200tdi ayre
Well-Known Member
Ill check again tomorrow but I was sure they wouldn't go in, if not, no hassle I can just put them back in
Ill check again tomorrow but I was sure they wouldn't go in, if not, no hassle I can just put them back in
jamesmartin
Well-Known Member
dowels are used were an exact fit/alignment is necessary they are usually a tight fit
200tdi ayre
Well-Known Member
Well James it looks like we're both right, there are dowels on both but in different places
This is the dowel positioning on the 200
And on the 300
So on the 300 they're on the top left and bottom right
And as you can see the holes that the dowels are meant to go into are too small, menace were both right
So I'm drilling out the holes to fit the dowels and filing to a perfect fit I thought this would be more accurate than fitting the dowels from the other engine which I tried to get out but couldn't get it to budge
This is the dowel positioning on the 200
And on the 300
So on the 300 they're on the top left and bottom right
And as you can see the holes that the dowels are meant to go into are too small, menace were both right
So I'm drilling out the holes to fit the dowels and filing to a perfect fit
I thought this would be more accurate than fitting the dowels from the other engine which I tried to get out but couldn't get it to budge
jamesmartin
Well-Known Member
as long as you have 2 and are good fit,why not use 300 flywheel housing?
200tdi ayre
Well-Known Member
jamesmartin
Well-Known Member
i havent read all the thread what are you fitting on engine ?
200tdi ayre
Well-Known Member
Short bellhousing lt77
200tdi ayre
Well-Known Member
Please tell me it fits ...
jamesmartin
Well-Known Member
more than enough studs would fit ,so i just use the 300 housing but am aware others use 200,disco 200 housing also has some that dont fit as well
200tdi ayre
Well-Known Member
The 200 housing bolts fit well within the 300 housing not 1 bolt would fit, this is an auto flywheel plate though ?
jamesmartin
Well-Known Member
auto plate hasnt anything to do with fitting 4 cylinder lt77
200tdi ayre
Well-Known Member
The 300 is out of an auto disco it's going into a lt77 90
jamesmartin
Well-Known Member
i thought you had a 300 manual flywheel housing as well ?
200tdi ayre
Well-Known Member
No the flywheel housing came off of my now dead 200tdi manual
200tdi ayre
Well-Known Member
Does anyone know the torque setting for the 130 clutch or is it the same as a sandard clutch ?
jamesmartin
Well-Known Member
it would be the same as uses the same bolts
200tdi ayre
Well-Known Member
jamesmartin
Well-Known Member
if your not going to use a 300 housing are you going to cut 200 out to fit over seal housing ?
200tdi ayre
Well-Known Member
Cut 200 out to fit seal housing ?
jamesmartin
Well-Known Member
some cut the D shape out like 300 housing so you still use 300 tdi rear main oil seal
