if it's not sitting level they will be all over the place.
Datatek
Well-Known Member
Possibly a leaking rear air bag then.
What are the measurements from the bottom of the rim to the wheel arch for each corner?
Read through the suspension system in RAVE (All Models version). There's a good description in there showing layout & functions for every component.
If the pump is working well, then check the main valve block & both front & rear cross-link valves for leaks using soapy water.
If the pump is working well, then check the main valve block & both front & rear cross-link valves for leaks using soapy water.
You'll still need to recalibrate it for the new sensors.
IMO if it thinks the rear is 2200mm then it's either trying to lower itself or more likely is way out of tolerence so is doing now't. TBH if it thinks it's that high I'd expect it to throw up a fault.
The voltages for the sensors don't look that bad to me.
The voltages for the sensors don't look that bad to me.
These were my voltages when I tested them so if you're on the bump stops I'd expect lower than my 1.96 & 2.01v.
If someone has calibrated it and put a silly value in that could well cause your issue.
If someone has calibrated it and put a silly value in that could well cause your issue.
Since when did LR use logic
Its what keeps us goingOf course you will you own a LR product
Nice one lad! Your hooked
Datatek
Well-Known Member
Thanks for the feedback
