She alive !! :tea:

Turns out I had managed to put the lwo tension tabs on top of the insulating washer for the points :der:

Reset the crank to 10degrees, reset the dizzy so the points were just opening, re-assembled and hey presto

Vroom Vroom
 
Didn't see much of you rtv'ing but the ccv was fun to lay out.

Are you going to Billing??

I am half tempted to go Sunday for a look see.
 
LOL, very wierd, I was setting out an RTV section, stopped the motor and got out to move the canes. When I got back in and turned the key there was nothing !

No ignition light, horn, lights, fuel pump or starter motor!

Strange, I checked all the fuses (have recently upgraded to an alternator and replaced the fuse box). All appeared OK.

Tried a spanner accross the starter switch terminals nada! Almost as if the battery was completely discharged or worse, failed.

Got djdommyp to trundle out with leads and a multi meter. That showed a nice healthy 12.8v accross the battery.

The we tested the Supply to the switch an it said zero. suddenly there were a few sparks and the fuel pump fluttered into life.

Turned out that tightening the terminals on the starter switch resolved it. Very bizarre.

On the bright side djDommy got his Disco stuck and had to be recovered by the 80. but he finally got his new rope dirty!

As C of C I didn't have time to take any photos, but it was a cracking good trial with 11 RTV and 2 CCV entries

03yK8s.jpg


tD7Lfq.jpg


oKBD35.jpg


gKygPm.jpg


wPESl3.jpg
 
It would seam that after a day's trialing Leebastard is now hooked. Good day out at Roundhill Woods with CVLRC, neither of us got placed but a cracking day in his 90

e9a5yzav.jpg


vavamyqu.jpg


juqemaru.jpg


3ajyqy9a.jpg


umy7edyh.jpg


regudede.jpg
 
They're the ones tread depth wasn't bad only for the off-roader just gotta fix a cheapo tread cutter I picked up a few weeks back and they'll be better than new!
 
Judging by the ground conditions and the weather forecast Sewell will be fun trial on Sunday
 
Looks like it will be a good one!!

Won't make this one not a member and need an Mot ASAP!

Just spent this evening fitting spreader plates for the NATO hitch got new headlights as one of the old ones were starting to corrode and one was cracked. Welded a reinforcing plate to the rear x member for the spare wheel carrier. Will modify the wheel carrier later to use generic spares.

Removed the 4 pin diff from a 90 rear axle. Will try to swap out my locker and axle ends in the front for hd ashcroft shafts and the 4 pin tomorrow. Hen it's just MOT Remove roof rack and we are ready to play RTV!!
 
Last edited:
Need to take the locker out I hink they would have an "interesting" brake test if they took
It out for a drive FWD lockered up!

Plus I want to get odds and ends tidied up before I send it for MOT. Looks a mess!! Tomorrow I'm thinking ill be ready for the next comp in December Sunday I'm doing IKEA and baby stuff because I need next Sunday off for a shooting comp in Northants.
 
You must log in or register to reply here.

Similar threads

RustHater
From Somerset and thinking of a disco 1 rather than my 1959 Series 2
Replies
14
Views
2K
Knappster
Knappster
Chalky.
Series 3 1972 mot and tax exempt project
Replies
1
Views
1K
beanwood
B
adrobinson1969
My Land Rover dilemma! A tale of woe, a warning to other newbies and a request for advice!
2 3
Replies
41
Views
7K
Bobsticle
Bobsticle
F
Too high mileage to tune and if not what's the best option.
2
Replies
33
Views
7K
lightning
lightning
edd4x4
Another ALRC project
Replies
5
Views
3K
edd4x4
edd4x4