bankz5152
Well-Known Member
LRS
KISSMYAURA
Well-Known Member
Use this, register and enter your vin, then all the parts relevant to your vehicle are shown, they have excellent diagrams as well, then all the parts shown show prices from different suppliers,
https://www.lrworkshop.com
I tend to use LRSeries and island 4x4 for most stuff cos they have stick and price is good, and they deliver with DPD, cant be doing with my herpes or any other happy shopper delivery company.
KISSMYAURA
Well-Known Member
superb cheers J-shhhh
thank you. No one likes herpes.
KISSMYAURA
Well-Known Member
New vented brake discs all round,
Last edited:
KISSMYAURA
Well-Known Member
Its that time again, and you will never guess who I saw on my way back after me truck passed its yearly exams, in a little village we call "bexleef" this morning scaring all the buses that were hiding in the in the bus station????
@bankz5152 any ideas?
Anyway my emissions are getting better--rer!
@bankz5152 any ideas?
Anyway my emissions are getting better--rer!
KISSMYAURA
Well-Known Member
A Frame today.
Arm bolts - doddle
Castle nut CNUT
Side cutter? oh yea compressor fooked
Mini recip saw? - as above
Air hammer? - as above
Cold chisel + extreme violence = Done and Done
Arm bolts - doddle
Castle nut CNUT
Side cutter? oh yea compressor fooked
Mini recip saw? - as above
Air hammer? - as above
Cold chisel + extreme violence = Done and Done
Last edited:
Turboman
Mab An Gov
Whang it round with the club hammer and cold chisel.A Frame today.
Arm bolts - doddle
Castle nut CNUT
Side cutter? oh yea compressor booked
Mini recipe as above
Air hammer as above
Cold chisel + violence = Done and Done
If it doesn't turn, you will cut through it after a bit.
Hicap phill
Well-Known Member
Unless you miss & tw@ your hand
Turboman
Mab An Gov
I have done that a few times too. But the hammer and chisel never fails in the end.Unless you miss & tw@ your hand
If the taper turns in the bracket, a long crowbar used as a lever on top of the ball joint stops that.
KISSMYAURA
Well-Known Member
Cheers all, but as i said Done and Done! Lemforder BJ and Supapro bushes all in.
Any ideas on Torque setting for BJ?
Any ideas on Torque setting for BJ?
KISSMYAURA
Well-Known Member
KISSMYAURA
Well-Known Member
Rear brake Lines replacement to Cupro- Nickel (cunifer) pipe with Braided Flexi + new fittings.
Last edited:
Nicely done! All these bits get so tired don’t they but your working your way through it nicely!! Did you go super pro bushes? I’m following behind you at the moment! I have a rumble still so doing output bearing on transfer and swapping wheels around in week just Incase it’s an alignment thing! Then I want to start bushing, bearings, swivels, brakes so similar tasks! Problem is, when the times there I just go fishing ha!
KISSMYAURA
Well-Known Member
yep supapro all round, its truely a triggers broom now!.
