robint

Well-Known Member

• Jul 23, 2014

• #1

right people ant been on here for a long time , so thought i would utilise all your experience ,


had new bcu fitted and syncked up with nanocon all fine untill you go to start it ??
not immobilised as all lights go out on dash etc !
im thinking could be dodgy starter , ive read somewhere its a common fault so ordered a repair kit can this be replaced in situ or easier to take motor out .................. anything else cause this problem i should check aswell
thanks all

ps d2 99 model

 

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Forum Sponsor

• Jul 23, 2014

• #2

Sounds like dodgy battery or excessive current drawn.

 

robint

Well-Known Member

• Jul 23, 2014

• #3

batts good current at starter just a a little click when trying to turn over

 

listerdiesel

Well-Known Member

Events Planner

• Jul 23, 2014

• #4

TD5 ?

Check the little strap between the solenoid and the terminal on the start body.

Peter

 

fanatic

RESPECT IS EARNED, BEATINGS ARE FREE ;-)

Forum Sponsor

• Jul 23, 2014

• #5

robint said:

batts good current at starter just a a little click when trying to turn over

Click to expand...

If it's td5 terminal repair kit as part of course.

If your getting dash lights disappear on trying to crank,fundimentally you either have bad battery/bad starter/seized engine or more likely high resistance and voltage drop on cranking current.
clean earths and battery leads

 

robint

Well-Known Member

• Jul 23, 2014

• #6

im finking its the little copper parts on starter worn ive got ne parts comming can they changed with starter in place or easier to take it out

 

T

ThomasCledan

New Member

• Jul 25, 2014

• #7

Mine did the same thing and it was the copper contacts in the starter motor, replaced them and starts first time now. It's a difficult job getting the starter motor off though, top nut is 15mm i think, bottom two are 13mm from memory. Top one is dificult to get onto.

 

robint

Well-Known Member

• Jul 26, 2014

• #8

quite an easy job to get out , so changed all the gubbins over inc plunger but still dont turn over ohhh nd i did a bench test no problem there , so im finking now i must be missing a relay or fuse somewhere ! but where ??

 

robint

Well-Known Member

• Jul 27, 2014

• #9

sorted !!

 

D

David Pye

Active Member

• Jul 27, 2014

• #10

and the cause was?

(for the benefit of the next person with this problem....)

 

robint

Well-Known Member

• Aug 1, 2014

• #11

terminal 30 bridged terminals 30-87 to check starter relay , relay lost signal so new starter relay required