UpandOver
Well-Known Member
New door skins and galv door tops arrived today from sp4x4. Bonded the skins to the original door frames that had been blasted repaired and painted. Hammered the edges over then a quick once over with 240grit DA. All ready for epoxy ali primer
Attachments
UpandOver
Well-Known Member
Well a very productive day, epoxy primed all the doors, sills, new door hinges and gave the wings another coat they’re all ready to go with the bonnet for some marine blue. Auxiliary dash panel refurbished, sanded and painted then found a replacement plastic cover strip with no damage on the net, ebayed a new brake warning light holder and a pull fog switch.
Just sat down with a beer and contemplating wiring in the dash …….
Just sat down with a beer and contemplating wiring in the dash …….
Attachments
steve2286w
Well-Known Member
That’s a cracking day deserve a few more beers, my task today was to stop the clanking exhaust by making a spacer for the clamp never got round to it , spent half a day cleaning out one cupboard
Can you show some pics of the landy as is please
Can you show some pics of the landy as is please
UpandOver
Well-Known Member
steve2286w
Well-Known Member
Incredible job you’re doing and not far away now, wiring up looks a bit of a headache, looks like you labelled up the old one which will help a lot
adrianhartopp
Active Member
Fantastic progress. Also, pleased to see you're looking after your physical health with the gym equipment in the background.....................
UpandOver
Well-Known Member
This weekends tinkering include , finishing off the wiring, fiting the dashboard. Glad to say that most things work, fitted new modern flasher relays, and I need a new dash light toggle switch, and the jury is still out on the fuel sender unit …. With so little fuel in the tank its hard to tell.
Attachments
UpandOver
Well-Known Member
This evenings handy work was fitting the windscreen and the handbrake. Although I messed up a bit while fitting a stainless rivet into the handbrake ! Doh ! Hammered the rivet thats half way down that holds the small triangle piece that connects the rod from the button just to realise that the rivet hadnygone through the triangle bit that it was suppose to hold ?!! Retard !
Attachments
steve2286w
Well-Known Member
That looks so good, brand new complete with the speedo with zero miles on too
UpandOver
Well-Known Member
A few hours in the garage today got the bonnet stay back together and the galv back panel rivited onto the rear tailgate.
Made the centre rivet on the stay was made by grinding a flanged m8 bolt to a rivet shape, heated it up red hot then hammered it flat and mushroomed the end.
Made the centre rivet on the stay was made by grinding a flanged m8 bolt to a rivet shape, heated it up red hot then hammered it flat and mushroomed the end.
Attachments
Last edited:
steve2286w
Well-Known Member
BikerB
Well-Known Member
I used them, drilled a hole and then put fresh paint in it. Used a punch to hit the clip in the middle. The hole needs to be a fairly tight fit to make sure they don't come out again. However for the pipe to the rear I used the zinc plated clips with the self tapping screws
