robbie the greatl
Active Member
puma 2.4 keeps cutting out till warm on cold mornings ok all day after any ideas lads
robbie the greatl
Active Member
thanks ive had it plugged in and no fault showing only maf not 100 % but ok intermitant whitch sensor to unplug
robbie the greatl
Active Member
if i fit a new maf sensor do i have to reset anything
If its running ok when warm the MAF sensor is unlikely to be at fault. If its rough on a cold start it could be the glow plugs are not working.
robbie the greatl
Active Member
its runs lovely when first started after a couple of minutes it starts missing then cuts out it starts again and same again three or four times till warm its like fuel starvation worse on cold days
robbie the greatl
Active Member
i thought that but its not that cold at the moment ill have a go at it tommorow ,im going to start it if it plays up i try taking wire of maff air flow sensor its got me baffled
I believe that if you unplug the MAF on a Tdci, it will just go into limp mode. Be prepared to plug your diagnostic tool in to clear the fault when you reconnect the MAF.
robbie the greatl
Active Member
i unplugged it while it was running made no difference so i cleaned it and put it back warmer today so was ok
robbie the greatl
Active Member
is that the sensor after the air cleaner?
Some light reading -----
robbie the greatl
Active Member
i cant download them my friend
robbie the greatl
Active Member
robbie the greatl
Active Member
thats fantastic thanks a million ive done a screen shot most usefull thanks again
robbie the greatl
Active Member
i took map sensor out it was so cacked up with carbon i couldnt see through it. i socked it in that moly stuff for cleaning mass sensors and gently cleaned it what a difference when i road tested it , i think it was first time cleaning since new 2007
