Sunny1995 · Jun 7, 2023

Same cable too

pwood999 · Jun 7, 2023

Ok, so next question is where did you get the Serial-Diagnostic cable ?

The USB-Serial looks correct, so suspect the Serial-diagnostic cable or the delay relay is not working. also check that someone hasn't done so wiring mods to the EAS ECU ?

. . . . . . . . and where are you located ?

Try this:

Rich (BB code):


Connect USB-Serial to Laptop
Ignition on so EAS ECU is powered, but no need to start car.
Connect Diagnostic cable to car, and then connect to USB-Serial
You should normally get the Dash beeps because the cable triggers the Delay relay.
Then when you try to connect in the software the relay should trigger again & dash should beep.

Grrrrrr · Jun 8, 2023

Worth checking the diagnostic socket on the car isn't green from corrosion but also the connector behind the passenger kick-panel.

Good call on the delay-timer under the passenger seat. Some people replace it with a standard automotive relay to stop it self-levelling after switching off but it also stops diagnostics working.

Liverghouls · Sunday at 00:39

Spridget said:
Hi Sunny
It took me a while to get the software to work but the problem was com ports. After much frustration and help from this forum I discovered that Com port 4 is the one to use. also apparently drivers can cause problems if the right one isn't installed. Mine works every time on Windows 10 now. If you still have problems there's a wealth of info on this forum and someone with more know how will be along.
Good luck.
Pete

Hi does this software work to calibrate a D4 after ride height sensor change ,where can I download it and what lead do I need to use please

thanks

Datatek · Sunday at 09:41

Liverghouls said:
Hi does this software work to calibrate a D4 after ride height sensor change ,where can I download it and what lead do I need to use please thanks

I suggest you go to the RSW site and check what is covered by their diagnostics

Grrrrrr · Monday at 11:18

Liverghouls said:
Hi does this software work to calibrate a D4 after ride height sensor change ,where can I download it and what lead do I need to use please thanks

I suspect the D4 is canbus so you would need one of Storey's other products and a decent diag cable to connect to your laptop.

Sunny1995

Member

pwood999

Well-Known Member

Grrrrrr

Technician, Bodgit & Scarper Ltd

Liverghouls

Member

Datatek

Well-Known Member

Grrrrrr

Technician, Bodgit & Scarper Ltd

Similar threads