discomark10
Well-Known Member
had an afternoon spare so got the seats all done, and started the hammerite
Last edited:
discomark10
Well-Known Member
Made some decent progress! got the cage all done, welded on, finished patching the cab, mounted the exhaust, and mounted the fuel tank!
Last edited:
wtf?
discomark10
Well-Known Member
???
discomark10
Well-Known Member
Thanks^^^^ i apoligise for the above coment... i left laptop on whilst i went for ciggy and my partner who gets anoyed with me always talking bout landys........ but liking the threadlooking good.
Hmm ill let you off
Get her a landy too, thatl shut her up!
better still - tell her to bugger off. what did her last slave die of?
discomark10
Well-Known Member
ha ha im trying to get her in to landys im slowly getting there managed to get her to sell a saxo for a little 4x4
my mrs enjoys landys, doubt shell swap her saxo for one tho lol
discomark10
Well-Known Member
look what arrived through the cat flap
time to fire it up tomorrow!!!
time to fire it up tomorrow!!!
Last edited:
discomark10
Well-Known Member
Got my tray almost done, managed to screw up the exhaust hole abit.. but sorting it
Last edited:
jai_landrover
Well-Known Member
remember that the water hoses need to be done in such a way that if they were to burt nobody can get burnt. should be shielded usually by a metal and should not pass through the cab unless again shielded in such a way if they burst nobody gets burnt.
discomark10
Well-Known Member
Made a filler neck for the fuel tank, turned down the end of a large threaded bit of brass and added a brass cap... soldered a bit on top for a opening handle
Last edited:
discomark10
Well-Known Member
Make some bracing for the chequer plate
Last edited:
discomark10
Well-Known Member
tank breather
Back end!
removable panels to gain access to tank
Back end!
removable panels to gain access to tank
Last edited:
wiltshire landyman
I’m back
i have to say and this is just my opinion youve now ruined that back end profile by making the bed all square it now looks like a bed has just been slapped on
rounded corners would have looked mint.
but hey its your motor and keep up the good work
a bit similar to the rear on this one but yours would obviously be a flat bed across
http://www.ebay.co.uk/itm/1992-LAND...3405208?pt=Automobiles_UK&hash=item3a78b7a818
rounded corners would have looked mint.
but hey its your motor and keep up the good work
a bit similar to the rear on this one but yours would obviously be a flat bed across
http://www.ebay.co.uk/itm/1992-LAND...3405208?pt=Automobiles_UK&hash=item3a78b7a818
Last edited:
discomark10
Well-Known Member
the main reason its squared is that there is only 1 place without travelling miles that bend pipe (scaffolding) and they are a freaking rip off!
so more fund derived, but it wouldnt be to hard to change at a later date, only a few pop rivets.
but i will see what it looks like after the sides go on.
so more fund derived, but it wouldnt be to hard to change at a later date, only a few pop rivets.
but i will see what it looks like after the sides go on.
Last edited:
discomark10
Well-Known Member
yea, thats been one of the biggest things to do, got a good plan set out tho
