dollydisco
New Member
Alright mate, I may be able to pop over on sunday! And also I never use viscous spanners, hammer and a sharp punch do the trick normaly, and if your good you don't damage the viscous nut
Alright mate, I may be able to pop over on sunday! And also I never use viscous spanners, hammer and a sharp punch do the trick normaly, and if your good you don't damage the viscous nut
sunday would be awesome as i have sooo much to do i've the cutting and welding to do on the disco along with getting the injection pump off and i've got to put the coilovers on the pugot as i've got that show next weekend so if you could bring the cam locking kit back over and a trolly jack if you have one as my jack the seals have just gone and i only have a sizzir jack now and i doubt that'd lift the landyAlright mate, I may be able to pop over on sunday! And also I never use viscous spanners, hammer and a sharp punch do the trick normaly, and if your good you don't damage the viscous nut
the nut is 32mm and paddoc wouldnt be able to get it out to me before sundayThe viscous spanner size is the same as the gearbox drain plug (at least it is on mine - a 300TDi) so it made sense to buy the spanner for me. It wasn't too expensive from Paddock Spares.
got mine from halfrauds if that helps
thanks L shall pop over there tommorrowgot mine from halfrauds if that helps
thanks L shall pop over there tommorrow
gasless welder welding stainlessLooks like you need to turn the gas up on your welder mate
boot floor costs about 50squid and are easy to get hold of..
gasless welder welding stainless
well i would now but the argon/co2 mix that halfraws sell is so expensive for something that lasts such a short time unless you know a cheaper place to get them from?Yeah best to get onto proper gas ASAP, the welds are better quality etc etc. Arguably its not critical on something like a boot floor which isn't structural, but on other areas of the car (eg near seat belt mounts on sills), or on other cars which are unibody construction, its more important to get the welding strong.