Getting there mate, I've put off starting mine until tomorrow 
What black is that?
What black is that?
Chrisw8
Well-Known Member
Thought I’d clean up some nut threads ... tapped and bunged bolts in covered in copper slip.
Having trouble with this one ....well 3 actually, anyone know what size thread it is , or what bits go onto it ? Could it be imperial ?
12mm seems too big and 10mm is too small.
Anyone says 11mm and I’ll come round and nut them !!!
Will spend all evening going through my phone photos to see what I took off there.
Having trouble with this one ....well 3 actually, anyone know what size thread it is , or what bits go onto it ? Could it be imperial ?
12mm seems too big and 10mm is too small.
Anyone says 11mm and I’ll come round and nut them !!!
Will spend all evening going through my phone photos to see what I took off there.
neilly
Well-Known Member
Magicgrotto
Well-Known Member
Think you will find they are Metric fine Chris
+ its a seat belt anchor
+ its a seat belt anchor
I thought they were 7/16 UNF for the dicky seats?
Magicgrotto
Well-Known Member
D/D69 is probs right on the thread
Chrisw8
Well-Known Member
Unless you're fitting the seats you could epoxy a bung in there just to seal the holes up.
I would have plug welded them over unless I was fitting the dickies back in there.
Magicgrotto
Well-Known Member
If you wont to clean the threads out Chris get 1 of your bolts & with a slicing disc & cut into the end of the bolt then re leave 2 sides to make it look like a tap & you can use to clean ALL the other seat belt mount threads & save that bolt till last
& you can use to clean ALL the other seat belt mount threads & save that bolt till last
Chrisw8
Well-Known Member
If you wont to clean the threads out Chris get 1 of your bolts & with a slicing disc & cut into the end of the bolt then re leave 2 sides to make it look like a tap
Are all seat belt bolts the same size then .?
Magicgrotto
Well-Known Member
They are on your motor & probs the same in all motors
Chrisw8
Well-Known Member
indeed, certainly a labour of love !!
