Chrisw8
Well-Known Member
trying to, got a busy week next week so might not get much done.
if i can get up to putting 2 coats of black on rear 1/4 chassis and axle, i'll be happy.
i noticed the mount point for the front end of the fuel tank is a bit thin, so might have to cut it out and weld a new bit on for that.
if i can get up to putting 2 coats of black on rear 1/4 chassis and axle, i'll be happy.
i noticed the mount point for the front end of the fuel tank is a bit thin, so might have to cut it out and weld a new bit on for that.
Mines shot mate. And underneath it. I think I'll use a but of thick angle that I can get from work if it fits the bill. I'd check engine it too. Have you noticed there's like hanger loops on the way it's attached? I think there are another rust trap. They do look like they have been made that way to take strain of the fuel weight though
They've both gone in all the same places! On another note, did you make some kind of arch liner when you did your arches or did you leave as metal? I'm waiting for a 30mm wrench to turn up at work for fulcrum. Once I can break that off I'm going to build me new axle in the lobby lol
There isn't. I built mine from metal too as per original-ish but wondered if you had put any additional measure in.
Like them rings, might have to pinch that idea for my own
