PastyMuncher83 said:

Got the cable from Datatek, he has been helping me a great deal with tech support!

Felt like I was p&@;img into the wind yesterday?!

Anyway, good news. The eas ECU wasn't plugged in nor the delay relay Comms with EAS switch is now working with a good green idle at last! Can clear the codes, but they are only 2.
Both for no signal from the front height sensors. Never been so happy to see a fault code before!!

I remember when I fitted the bags both rear sensors where unplugged and the cable cable tied out the way. So I cleaned them up and plugged the rear HS's back in.
Never did the fronts. Checked them and they are also unplugged. I've had to stop work on it for now unless I fancy getting divorced but managed to drop down one of the front arch liners and hey presto the lead for the front height sensor is cable tied out the way. Hopefully I will just need to plug this back in & the other side and fingers crossed could be in business.......will have to wait until next weekend to start but there is light at the end of the tunnel

Thanks for all the help

Click to expand...

PastyMuncher83 said:

Got the cable from Datatek, he has been helping me a great deal with tech support!

Felt like I was p&@;img into the wind yesterday?!

Anyway, good news. The eas ECU wasn't plugged in nor the delay relay Comms with EAS switch is now working with a good green idle at last! Can clear the codes, but they are only 2.
Both for no signal from the front height sensors. Never been so happy to see a fault code before!!

I remember when I fitted the bags both rear sensors where unplugged and the cable cable tied out the way. So I cleaned them up and plugged the rear HS's back in.
Never did the fronts. Checked them and they are also unplugged. I've had to stop work on it for now unless I fancy getting divorced but managed to drop down one of the front arch liners and hey presto the lead for the front height sensor is cable tied out the way. Hopefully I will just need to plug this back in & the other side and fingers crossed could be in business.......will have to wait until next weekend to start but there is light at the end of the tunnel

Thanks for all the help

Click to expand...

tomcat59alan said:

I bid a whole bag of black miget gems

Click to expand...

PastyMuncher83 said:

Well I couldn't wait till the weekend so took today of work. Plugged in the front height sensors, cleared the fault codes, no new ones read. Very excited to fire up with the door open to pressurise the system.

Then discovered that the compressor wouldn't run!! I had tested it after the rebuild and worked fine on the bench.
Began contemplating the true value of black midget gems!!
Opened the engine fuse box lid and to my delight the relay for the compressor was missing Poached a relay for the heated front screen and tried not to get too excited as was preparing for another failure.

Then, quite unbelievably, fired it up, charged the system with compressor running as it should. Once the compressor stopped, got in, shut the door...........and would you believe up popped the back and then the front!!!
Have been for a short 30 min test drive and it seems to be working perfectly, I am over the moon, at last

Click to expand...

mozz smith said:

well done pasty now send cakes to everyone ...oh and some pasties ,,,,me first ,,, good luck - mozz

Click to expand...

tomcat59alan said:

Mmmm, lots of pasties for all the support, YES. PM for my address, bags I'm next after Mozz

Click to expand...