Ahhhhhhh so useful!! Thank you!
Thanks for the offer! Not got much left really few bits! But thank you none the less
No worries and always happy to help
Must admit have had to extend my tool kit somewhat since owning the disco
Ahhhhhhh so useful!! Thank you!
Thanks for the offer! Not got much left really few bits! But thank you none the less
love the see through hole in engine lolWow. Thats an impressive fail!!! Christ how much boost ya think went thru that!?
No worries and always happy to help
Must admit have had to extend my tool kit somewhat since owning the disco
love the see through hole in engine lol
Since owning a landy my tools have expanded from one spanner to about 30 and at least half a garage full
Where all this stuff is guna go when i move out who knows
Bloody hell thats blown some!!!!!
Day off today so trying to get a lot done!
First up A Bar welded up
View attachment 154158
All welded up and ready for a lick of CIO basecoat. I had them weld in a bar at the rear too so I can choose to mount my lights where ever, also adds a little strength
View attachment 154159
Dropped off the landy for the AC to be checked/repaired depending on whats wrong with it.... Hope its an easy fix!!
Soon as I get it back straight onto fitting the slotted discs! Hopefully be done by 7pm
Bad news from the AC check. New condensor needed (no shock really as mines rotten) leaking heavily from both seals and missing 60% of the cores.
£350 supply and fit a new one aint bad at all imo!
Ouch , bet I will also have to replace mine, are u getting an allisport
Condenser and new dryer for mine is £80
Allisport dont make AC condensors as much as I ask them
Three coats of coarse FXLiner and its on!
View attachment 154213
View attachment 154214
View attachment 154215
View attachment 154216
Fitted with x2 M12s bolted through and will be fitted with x2 M10s and a rivnut (youd need very bendy child hands to get in there otherwise!) Should hold it enough.
Got the slotted front discs fitted aswell, pretty basic job took about an hour per side.
Splitting the disc from the hub
View attachment 154217
Drifted on with my new rawhide hammer (for work actually but perfect for this!)
View attachment 154218
Good trick a mate taught me when torqueing up discs, makes it a very simple job. Added some high strength loctit for good measure.
View attachment 154219
Got rid of the awful "mud guards" all ive gound they do is trap ****, score the discs and make a god awful noise. Skip for them. Cleaned up the area a touch, also noticed a bit of play in the swivel bearings dropped two shims and all gone
View attachment 154220
Pretty ay
View attachment 154221
Protective layer gone, still look pretty
View attachment 154222
All in all rather succesful day! now for the damn annoying part...
New calipers
New discs
Two different sets of pads - Brembo & Ferrodo
New pad fitting kit
Special brake grease
THEY STILL SQUEAK!!
So im going to fit new rear pads and fitting kit and hope for the best. If not then i guess ill be driven insane
So,
Did you put the discs on the right way for the slots to work?
Cheers
That is tight! lol it was loosened again after I found play in the swivels but I'll double check now! Thanks
Hi mate
They should stop u and looks good mate , test is in the pudding so to speak ,
Have u tried ceramic brake grease , lol
should look better with a few spots and the winch fitted.
Make sure you have enough space to fit the lights and the winch, iirc we covered this before..
Will look better with the winch fitted. You going rope or wire?
Cheers