Neptune19522

Active Member
Drove 76 miles then six hours later turned the key, cranked well but no start. M&S light and the three Amigo's flashing. Checked the Crank Sensor with a oscilloscope and got a good signal. RAC chap send e-mail of faults - CAN bus error and Gearbox position switch error. Had a spare switch but no improvement. ECU red connector oil was washed out but still no start.
Retired Land Rover electrical Project Development employee and lots experience with wiring harness; so happy to change any connectors or pins, which I have, but which pins need cleaning / replacing? Any one got any ecperance or similar problems and perhaps the cure...
 
Drove 76 miles then six hours later turned the key, cranked well but no start. M&S light and the three Amigo's flashing. Checked the Crank Sensor with a oscilloscope and got a good signal. RAC chap send e-mail of faults - CAN bus error and Gearbox position switch error. Had a spare switch but no improvement. ECU red connector oil was washed out but still no start.
Retired Land Rover electrical Project Development employee and lots experience with wiring harness; so happy to change any connectors or pins, which I have, but which pins need cleaning / replacing? Any one got any ecperance or similar problems and perhaps the cure...

I had a similar issue but had the hazards flashing as well. It was the inertia switch. pressed that in, opened and closed all the doors and tailgate and it started.
 
Welcome to the forum
I7pha4t.jpg
 

Similar threads