the_wolf said:
To be fair to him I don't torque my wheel nuts either. I tighten them up properly as I've been taught and never had any problems whatsoever. Then again I'm pretty strong ;)
Click to expand...

I don't either I just use the impact gun :p but he should check and re tighten them after a bit just to make sure they're still tight :rolleyes: if someone had tried to nick them I'm sure they'd have gone for more than one wheel

Unless he's ****ed someone off and they wanted revenge :rolleyes:
 
well i went 4 some dinner n there was a bloke there whos a complete cock hes a bully n he dnt like me i wonder if maybe he loosened it off
afew yrs ago his m8 glassed me n hes just a bully himself hes strted on me afew times for no reason
 
To be fair, it can happen to almost anyone.

There was case a few years back near here when some little scroat with a grudge took the bolts out of both front wheels on a panda car. The local plods did get him 'cos he hung around to watch the fun!
 
Overtightening can be as bad as undertightening, the studs stretch and the nuts end up loose.
 
Dr_evil said:
I don't either I just use the impact gun :p...
Click to expand...

Noooo that's even worse. I hate that. There's nothing more of a pain in the arse than when someone's putting yer wheel on and they just whack the nuts on with an impact gun or an air gun. You go to the gym don't you, use your muscles like you should ;)
 
peter mcn said:
either way i weigh 16 stone n if i put my weight behind the brace its gonna tighten
Click to expand...

SteveD said:
Overtightening can be as bad as undertightening, the studs stretch and the nuts end up loose.
Click to expand...

lorri789 said:
Tell that to the dicks at Kwikfit.
Click to expand...

I was quite shocked the D3 only requires 140Nm on the wheel nuts - it's not a lot really.


The garage i used last, well respected local tyre place, did the nuts up so much that when I then got a puncture in Scotland the garage snapped the snap-on socket trying to undo the wheel nut and gave up on me.

I got it off by whacking on a socket, then using a very long bar and a lot of jumping. (i then changed the hub to be on the safe side)
 
the_wolf said:
Noooo that's even worse. I hate that. There's nothing more of a pain in the arse than when someone's putting yer wheel on and they just whack the nuts on with an impact gun or an air gun. You go to the gym don't you, use your muscles like you should ;)
Click to expand...

nah you give it a quick spin with the impact gun on low setting then torque wrench to finish the job ;) partly cos I'm lazy and it saves a bit of time per wheel :eek:
 
You must log in or register to reply here.

Similar threads

E
Help removing broken front Indicator holder.
Replies
5
Views
550
GrumpyGel
GrumpyGel
Montyjohn
P38A What are the plastic lugs on the back of the steering wheel for?
Replies
8
Views
903
Montyjohn
Montyjohn
R
Confused Newby
Replies
17
Views
2K
CohPC
CohPC
Skyisthelimit
No impulse on Discovery 1 1991 model V8 3.5 right hand drive.
Replies
12
Views
835
classic kev
classic kev
T
TD5 crank no start after overheating
Replies
1
Views
470
tom1979
tom1979