Roof seal question

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

joe27979

Well-Known Member
Posts
1,354
Location
west Norfolk
Gents/Ladies

Im putting the roof on and have some corner seals MUC6400 but am stuck as to where they go.
The parts diagram doesnt really show too well where they go so im after some advice..see pics attached : there is a seal in the roof, and i have stuck down the roof to windscreen seal strip, i just need to know where these little square seals go.

Any help or advice appreciated.
 

Attachments

  • IMG_1785.jpg
    IMG_1785.jpg
    239 KB · Views: 2,012
  • IMG_1786.jpg
    IMG_1786.jpg
    239.4 KB · Views: 3,478
  • IMG_1787.jpg
    IMG_1787.jpg
    232.4 KB · Views: 2,712
  • IMG_1788.jpg
    IMG_1788.jpg
    241.7 KB · Views: 2,293
I think they go on top of your door pillars, driver and passenger. I replaced similar to you last year and dont recall they go on the screen/front seal. Just wait a see if anyone else can confirm.... I just checked my 110, it has similar on the door pillars...plus dumdum sealer. If you ring Paddocks, they are very helpfull and have it all on screen
 
Thinking back.... pic 2, I think they stick onto the roof corner not the screen frame itself.... between door rubber and screen seal. Besides a 90 dont have a 2nd row door pillar... its a bit early for me :)

aha, so if i stick them to the front flat underside of the roof under the guttering end it would stop water from the gutter running back under itself into the door seal area? possibly?
 
prehaps you could ask the people you brought you untraceable baulkhead off,they seem helpfull to sell you stuff.....

I find you quite a bore, your immaturity is very tiresome fella...maybe you should get out more! Anymore character deformation from you and I will take considerable and appropriate action against you!
 
i think he was getting at the amount to spam that gets put on peoples post. it can get a bit boring at time as some posts are so long and they get so much spam people just cant be bothered to read through it all.
 
I have just done similar and found an annoying space between the window panel and roof at the front above the drivers head.. I cant work it out.

The ends are in perfect alignment and the passengers side is fine but there just seems to be a gap about an inch in... Has anyone seen this ?

I can only think the roof bent ?
 
Back
Top