What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
i hope no one from the forum is waiting to bid on your car mate,
Shoosh you. It actually looks fantastic. It's in better condition than when i bought it. Cruise control's working now too. Replaced the hoses and jobs a good un. Must have been a split i couldnt see
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
Shoosh you. It actually looks fantastic. It's in better condition than when i bought it. Cruise control's working now too. Replaced the hoses and jobs a good un. Must have been a split i couldnt see
was you wot rote it.:doh:
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
After changing the hoses, the CC worked for a while, then it stopped
So, took the whole lot apart, everythings connected ok, no dodgy connections
Has the vac unit been known to be dodgy at all?
only in yours hammy.
:behindsofa::bolt:
gemsdad
NOT BOTHERED.
- Posts
- 67,807
- Location
- halfway between here and there.
:hysterically_laughi:mooning:
![[JP]](/data/avatars/m/29/29578.jpg?1437394565){kind=avatar}
[JP]
New Member
- Posts
- 3,980
- Location
- Newbury, Berks
I havent done anything to it....
but ordered gear and transfer box breathers and timing belt cover breather... as the cold water hiting the timing case, even with the wading plug in, sucks water, so with the breather if it wants to suck anything it will be air up near the snorkel...!!!
but ordered gear and transfer box breathers and timing belt cover breather... as the cold water hiting the timing case, even with the wading plug in, sucks water, so with the breather if it wants to suck anything it will be air up near the snorkel...!!!
- Posts
- 83,296
- Location
- Embasinga stocæ
fixed the ns door mirror
found the os door mirror motor lugs are broken
found the os door mirror motor lugs are broken
Sirus
Your all Banned except me
- Posts
- 22,196
- Location
- The Country of Black
I have a collection of assorted mirrors
- Posts
- 83,296
- Location
- Embasinga stocæ
and headlights
jai_landrover
Well-Known Member
- Posts
- 13,392
- Location
- Luton
brnocz
New Member
- Posts
- 564
cleaned it out , washed it took pics ,which didnt turn out, if its not sold by 2nd week in september it goes to the scrap man.
took off the rear hub as it was ****in out grease after 500 miles expecting yet another bearing failure....just the hub seal that was fooked this time..NOTE TO SELF DO NOT BUY ****PART BEARINGS AND SEALS AGAIN. :doh::doh::doh::doh::doh::doh::doh::doh:
landy10
New Member
- Posts
- 1,872
Jus declared mine SORN as i aint had the time to replace the clutch master cylinder yet. It only went back in may! would like to get the roof off it and get it the garage and clean the chassis up and wax it. Its also due MOT at the end of the month
- Posts
- 44,915
- Location
- Hornchurch
messed abouit with me handbrake
baggyjim
New Member
- Posts
- 2,063
- Location
- gillingham dorset
soldered lots of wires together to finish loom, just got lots of bits to put on the ends:doh:
dirtyrhino
New Member
- Posts
- 617
Finally got round to tweaking Muckys' engine a lil' today, and finished off the winch install......noticed the timing belt is overdue for chaning accoring to the log book ....... noticed the o/s swivel seal is leaking ....... ho hum.
once all that's done .............I might even wash it a lil.
once all that's done .............I might even wash it a lil.
[JP]
New Member
- Posts
- 3,980
- Location
- Newbury, Berks
I have't done anything yet…but will be fitting these beauties later, which have just arrived..
Gear box, transfer box and timing belt cover breathers, with a neat manifold to join with my axle breathers and then run one single pipe up to the snorkel!!
Gear box, transfer box and timing belt cover breathers, with a neat manifold to join with my axle breathers and then run one single pipe up to the snorkel!!
Similar threads
Discovery Sport
Need some advice please
