Latest activity

Putting polish on a surface then spreading it evenly, maybe letting it dry if it is that sort, then buffing it, cannot harm the surface. But using polishes that contain cutting compounds to remove oxidisation could eventually cut through the top...

As above, can you post photos of what you are calling the air con loom?

Yep. Problem is we dun't use them at wuk. So eye can't borrow them.

thank you so MUCH .. it is a bit on the way to be able to document my project 👍

Haven't I seen cable ties with a release tab on em? Makes em reusable..

It took them long enough to realise that :p

Hope you get it sorted. Go and say hi and stick up some photos, we all like photos.

Hello ! How do I remove this screw ?

What does it do? Does it reduce the traditional petrol smell from the engine area in use?

Thanks Guys

Just being cautious I guess, same as removing geolocation from photos. Although it would be diff to nick it now without any brakes 🤣

6.6mm ov rain since last nite. Weren't eggspecting it. We is now back up to 1100L. Nuvva 50L and we be spillin over.

Simular problem ere. Eye has to cut and replace the tie wrap when eye want to take me burd feeder down, to clean it.

The YRM replacement parts are steel, the end cap is ally and the new profile sits next to the body so further risk of oxidisation.

Caught in time. Where the steel meets the ally it will get gaffer taped.

I was going to go for half a Wispa but in light of your startling claim may need to have further discussion with my LZLawyer4U. I just hope @MGT is ready for this and isn't just ignoring it. ;) 😁

A crow keeps pulling my bird feeder off the stand so it can get all the spilt seeds, I'll need to cable tie it on but then its a bugger to fill. I dont want to bend the stand as it will crack all the coating. Got a squiggle coming to it, used to...

Morning all, tis very quiet here but thats about to change as the grinder is coming out :D Off to tackle the other inner wing, the rain set me back yesterday.

Just checking in, with another coffee. Plenty of ignoring going on today. Off to tidy my garage in a minute, so will ignore from there too. @MGT

@MGT have you seem the trouble you have caused… Having to ignore this thread is causing sleepless nights. Off to the doctors to see off they can help.

Thanks very much for the reply, very new to this, only bought the defender a couple of months ago.

Just out of interest - why did you obscure your number plate ?

Have you confirmed the cost per year for tax and insurance? Freelanders are bad enough but Discovery's........

Pics- you dirty boy, I’m a gentleman don’t you know 😉

So the goal for today is to get the coolant pump controller Arduino installed then the charger. While the new VCU can theoretically send the required 2hz PWM that the coolant pump needs it is not simple and I have another reason to go with the...

Is that to be shared between survivors? Or each. I think @MGT needs to sort himself out a brief.

Its standard fitment for thor discos.

Anyone used a Gunson Gastester to set up carbs ready for MOT? They seem really cheap compared to the 'professional' testers so I wonder if they are sufficiently accurate to get emissions, particularly on early carb V8's, below the required MOT...