Latest activity

Cheap calipers are terrible

The dash LED only show the alarm is set. Sounds like you need door latch microswitches changing. Does the car does unlock & lock on the FOB ? If not you also need to sort that, or you will wear out replacement latch as well !!

The Nanocom numbers also change in real time, but not in photos !! RH blend pot or motor definitely not correct. Best way to see is to unplug from HEVAC, and put a ohmmeter across the pot wires. Then move them with a 9V battery & see if the...

Well it will mark it, but then fit a new one as noted above.

Hi I'm new to this forum also new to the land rover world of problems if any one could give me any advice or point me in the right direction I would be grateful!.........recently purchased a landrover discovery 4 2010 106k the problem is when I...

Hi Tom, mine will not go above 82-84 as well.. I'm not sure if that's a good thing tho. Did you changed the thermostat at one point?

https://www.ebay.co.uk/itm/251640849016 Only cheap

James hasn't been around for several years unfortunately - but if he said those are the right bits, then the odds are infinitesimally small that they're not!

👍👍👍

Good going. You managed to stay awake then or did M do some driving 🚔🚔

Fitted an Offtrek snorkel/raised air intake. faff of a job which you need mr.tickle arms for, luckily i'm skinny lol. see pics @ https://www.landyzone.co.uk/land-rover/fitting-a-snorkel.392344/

Well i fitted it today, the pipe goes into the convoluted pipe marked in yellow with the reducer between. pipes were a faff to get off as caked mud had turned to concrete, but once of and washed they softened to make it easier. needed a bit of...

So runs fine but stalls if you let it idle? If you got a manual choke on it, see if it idles on half choke - could be fuel filters?

Will this not crush the shaft of the tap as it is brass ?

That last number changes as in the pic above but not on the rh blend. Nano reporting no faults on the rh blend though.

Darn, posted accidentally before I'd finished. The right blend motor above stayed on 65 even though I'm getting no faults on nano for that. The left blend motor..that number changed? More pics to follow.

New is best but turn the shaft with a mole/vice grip to close for now.

Yeah...I sort of did that yesterday, I took screenshots as I tried to put a video on here before and it wouldn't let me. Screenshots aren't much help on a moving screen really. I'll put some up anyway.

Hello I was draining my engine block today and as I was tightening up the engine coolant tap on the block the wing nut started spinning freely. The tap is still drilling water out from the flush. How can this be fixed and close the tap ?

Sorry to resurrect an old thread, but I am preparing a short bellhousing R380 to go into my 110. I am struggling with clutch pushrods as there seem to be various options. I'm not sure why there is much difference as despite the various bell...

So... Managed to get the Ryobi brushcutter started and running but having trouble persuading it to tickover. I have only ever done the same thing before storing it, namely to empty all fool out of it, run it until it stops then pull the starter...