Yoke / nylon selector cup

Lewi112 · Nov 4, 2020

Hi guys just a quick question and probably a stupid one I’m fixing my gear selector as it was full of mud , I have looked online and I can’t find much information I’m trying to find out how tight the connection should be between the lower gear lever and the nylon selector cup currently it’s slides the entire way through

flat · Nov 4, 2020

what do you mean 'slides through'? The nylon bit should be a cup that the ball just sits in. Grease it and let it sit in there

Lewi112 · Nov 4, 2020

flat said:
what do you mean 'slides through'? The nylon bit should be a cup that the ball just sits in. Grease it and let it sit in there

Yeah I know but is it supposed to be a tight fit in the top of the cup or does it just freely sit in with movement allowed

flat · Nov 4, 2020

Lewi112 said:
Yeah I know but is it supposed to be a tight fit in the top of the cup or does it just freely sit in with movement allowed

sots freely with movement allowed but it shouldn’t be ‘sloppy’

If in doubt just replace it, you can get the nylon cup seperate

Lewi112 · Nov 4, 2020

flat said:
sots freely with movement allowed but it shouldn’t be ‘sloppy’

If in doubt just replace it, you can get the nylon cup seperate

looks like I’m replacing it then , can’t seem to figure out where the vauge gar changes are from

Yoke / nylon selector cup

Lewi112

Member

flat

Well-Known Member

Lewi112

Member

flat

Well-Known Member

Lewi112

Member

Similar threads