Window Regulator in bits..

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
storm99

storm99

Spreading Joy & Harmony
Posts
21,065
Location
Brexited. Living on an island.
Righty Ho...finally got round to taking door card off to see why the window drops down as soon as i touch the electric button and wont go all the way up again...had a good idea it was the regulator..

Anyways..i noticed it wasn't sitting in the horizontal bar thats attached to the scissor like mechanism..as i tried to guide it on this bar, which was bit rusty, fell off! Poo, i thought...good job i've ordered a new one...

Then i touched the button to get the window up and the damn thing works...sort of!! It will go halfway down and then up again no prob...more than that and it has to be guided...so now it works better than it has for ages as long as i dont wind it down more than halfway!!

I'm confused!! I'm tempted to leave it as it is...cos fitting the new mechanism looks like a bugger of a job. Do i have to take the inner door skin off? :confused::confused:
 
No not at all, it's a straight forward job. the frame around the window can be removed by a few bolts.

The wing mirror comes away too.

It's easier than trying to fit it all inside the door while the glass is still in situ.
 
you just need some wedges to hold glass up out the way,after slackening the 2 bolts holding window to regulator ,lower regulator to lowest point with switch undo all bolts and plug ,it will come out of bottom hole in inner skin refasten in and raise regulor by switch so bolts are visible to reattach window dont need to remove frame or any thing else
 
When I did mine I had to detach the motor first to get the regulator out of the door but then later I read you don't have to do that ... but we will see won't we... a bit of a pain on the back of my hands with the sharp edges but it only took me a hour to do one very cold January morning and that's with the lining up of the motors drive cog with the regulator.

Only for D2 does the book say remove the top frame but it can be replaced without.
 
It can be removed without taking the top frame off or the glass out. Mostly the job is done with the glass still in.

It can be an awkward job made worse by sometimes the bottom rail on the glass is rusted up or has come away from the glass due to the rubber that holds it perishing.
 
I used one of those dent suckers on the glass to hold the window up whilst slicing my hands getting the regulator out-you are going to enjoy this Storm:D:D:D
 
jamesmartin said:
how did you manage that ,its quite a simple job
Click to expand...

Sounds like its easier on a D2 than a D1 James...there's no bolts on the doortop to take panel off, seems to be a case of drop it whilst holding/securing glass...then wiggling it out of the small holes in the bottom of the door before cutting hands to pieces forcing new regulator through a gap thats about 3 inches too small...looking forward to it. i might wear ovengloves.
 
You must log in or register to reply here.

Similar threads

Rickspark
D2 Front window regulator slider
Replies
1
Views
233
Rickspark
Rickspark
L
Disco 3 (LR3) I return to the fold with a Window Fault
Replies
6
Views
563
johnlad
johnlad
R
Window winder mechanism fit all doors?
Replies
1
Views
512
Hicap phill
H
G
Drivers window
Replies
0
Views
841
GerryN
G
MAF Diver
Disco 2 Cheaply treat this invisible rust hidden deep in the door?
Replies
10
Views
742
sierrafery
sierrafery
Back
Top