hugh bathe
Member
- Posts
- 76
- Location
- taupo newzealand
Hi
what are the internal components in the vcu unit on a freelander
what are the internal components in the vcu unit on a freelander
vcu
- Thread starter hugh bathe
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mondo
Banned
- Posts
- 7,631
- Location
- Yorkshire / Buckinghamshire
some plates with slots in and some sticky stuff wi sillycun balls in it
hugh bathe
Member
- Posts
- 76
- Location
- taupo newzealand
thanks
Northern Irelander
Well-Known Member
- Posts
- 2,890
- Location
- N. Ireland
Do a search , it has been mentioned so many times.
It appears that the silicone based fluid can not be replaced, if so it has to be around 80 something percent, the thin plates have microscopic burrs all over them.
At present we do not know of any way to service the VCU.
Ianh1 from Aussieland had some ideas about doing away with it, as did Mad Hat Man and Co., search for 2wd/4wd and Mondo mode.
It appears that the silicone based fluid can not be replaced, if so it has to be around 80 something percent, the thin plates have microscopic burrs all over them.
At present we do not know of any way to service the VCU.
Ianh1 from Aussieland had some ideas about doing away with it, as did Mad Hat Man and Co., search for 2wd/4wd and Mondo mode.
- Posts
- 83,300
- Location
- Embasinga stocæ
hugh bathe
Member
- Posts
- 76
- Location
- taupo newzealand
drill a small hole in the vcu and put in crc then recap the hole ?
- Posts
- 83,300
- Location
- Embasinga stocæ
yu try it - and tell us whether it worked or not
hugh bathe
Member
- Posts
- 76
- Location
- taupo newzealand
do you think that it could be possible
- Posts
- 83,300
- Location
- Embasinga stocæ
nope - but give it a try - if yu got nothing to lose - its by peeps trying out new things we learn wot can and cannot be done.
austen
Active Member
- Posts
- 455
- Location
- Worcestershire/Shropshire Border
We recondition these units, but you cannot buy the fluid, we have had to get the fluid especially made up in a large (and expensive) quantity. I searched for months to get the right fluid and only found 1 place in the world to supply it. You also need special jigs to reassemble the units. Trust me, its not worth t for 1 unit.
Similar threads
