Cassie
New Member
- Posts
- 314
- Location
- Cambridgeshire
Any views/preferences for these on a 110 CSW? Take it I should go for wich points and can I put me steps back afterwards?
UK to Oz - Rock Sliders
- Thread starter Cassie
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ratty
I'm not special I'm limited edition
- Posts
- 34,277
If you go for ones with tree sliders/guards you have steps at the same time. (not quite as good as proper steps though). Yes you can put your steps back on after as long as they are bolt on sliders not weld on. You are better off with ones with jacking points cos it gives you more jacking options in an emergency.
GUARDIAN 110 ROCKSLIDERS ROCK SLIDERS + TREE GUARDS on eBay, also, Land Rover, Car Parts, Cars, Parts Vehicles (end time 11-May-08 18:29:12 BST)
Griffdowg
New Member
- Posts
- 7,194
- Location
- Somewhere in Bristol
dont look at them as rock sliders, look at them as jackable sills. doubt you will have much call for sliding over rocks or infact fending off trees. BUT they are very very handy to use as a jacking point. just slip the Hi lift under it and stack it up!
when you say steps, i presume you mean, fitting them AS WELL AS the sills? not sure how they mount but as ratty says tree sliders can also double up as a step.
G
when you say steps, i presume you mean, fitting them AS WELL AS the sills? not sure how they mount but as ratty says tree sliders can also double up as a step.
G
A good idea as a extra safety item to prevent side intrusion in case of accident involving other vehicle from side , about the only vulnerable point on a 110 . they are also useful as jackable sills as mentioned. The individual hinge down steps on 110 can be fitted as well, and would be useful as a more substantial step there being no conflict as you would not need the rocksliders for their original purpose I think. HTSH
Ethan13
New Member
- Posts
- 23
- Location
- Shoeburymess
Hello Folks. Anyone out there know where i would attach jackable sills on a 110. gonna make some meself, coz i'm a welder ( and cheap)!....... any info appreciated!
