defender 90 300tdi
New Member
- Posts
- 61
- Location
- Sparsholt/winchester
Is there anywhere you can get a plate to attach the spare tyre to the rear bulkhead (behind the drivers seats) in a 90 CSW?? Cant seem to find nything of the sort?! 
Tyre mount for rear bulkhead??
- Thread starter defender 90 300tdi
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
hughesy
Well-Known Member
- Posts
- 4,200
- Location
- Isle of Anglesey
They used to fit em to series landies have a look on ebay.
defender 90 300tdi
New Member
- Posts
- 61
- Location
- Sparsholt/winchester
guess i could just use/adapt a bonnet mount kit sumint like this Land Rover Defender 90/110 Spare Wheel Bonnet Mount Kit on eBay (end time 22-May-10 23:16:43 BST)
Personally id just buy the door spare wheel bracket (if you done allready have one) and as said, mount it to the centre bulkhead reinforcing it with a spreader plate - job done and it'll set you back quite a bit less than that bonnet mounted wheel mount.
Ollie
Ollie
guess i could just use/adapt a bonnet mount kit sumint like this Land Rover Defender 90/110 Spare Wheel Bonnet Mount Kit on eBay (end time 22-May-10 23:16:43 BST)
For starters, that eBay bonnet kit is bloody expensive, considering that it's missing all of the important bonnet strengthening bits
This is what it should have -
The bonnet and rear door mounts won't fit on the bulkhead.
The bulkhead isn't high enough to mount either of these carriers with the spare wheel mounted onto their studs, the carrier would have to sit higher than the bulkhead for them to be able to work.
The proper, bulkhead mounted spare wheel stowage fittings are shown below -
.
