Today

Rachelkgr said:

Finally, today I am;

a) setting the heights with the EAS software and Datatek 's lead. Been looking forward to completing this task, since I now understand the issue in regard to recharging the air. e.g leave the door open and run the engine for awhile between each height setting.

b) removing the white connectors in the footwell that have broken pins.

c) Fitting a Walnut handbrake handle. If I can workout how to remove the old leather one!

A good day ahead!

Rach

Click to expand...

doz said:

Rachel, Will you marry me? Once we've had the wedding you can fix my car to your hearts content!!!! I've got a nice Lotus here you can play with......... after you've cooked me dinner

Click to expand...

Rachelkgr said:

Finally, today I am;

a) setting the heights with the EAS software and Datatek 's lead. Been looking forward to completing this task, since I now understand the issue in regard to recharging the air. e.g leave the door open and run the engine for awhile between each height setting.

b) removing the white connectors in the footwell that have broken pins.

c) Fitting a Walnut handbrake handle. If I can workout how to remove the old leather one!

A good day ahead!

Rach

Click to expand...

Datatek said:

No need to open the door and re-charge between each setting, just leave it idling and it will keep the tank topped up nicely.

Click to expand...

Datatek said:

No need to open the door and re-charge between each setting, just leave it idling and it will keep the tank topped up nicely.

Click to expand...

Rachelkgr said:

Will do, Thank you.

Rach

Click to expand...

Saint.V8 said:

With the doors and tailgate closed closed, open the passanger front window, drape lead throw window and laptop on bonnet...this way with engine running, doors closed and etc will keep it topped up, compressor running and height changes possible!

Click to expand...

tomcat59alan said:

Not so wise, don't throw window and laptop on bonnet sorry couldn't stop myself

Click to expand...

doz said:

Rachel, Will you marry me? Once we've had the wedding you can fix my car to your hearts content!!!! I've got a nice Lotus here you can play with......... after you've cooked me dinner

Click to expand...

dogsbody said:

So you're going to

a) get it up and make sure that it stays up

b) wrap it in some tight fitting rubber

c) grasp it firmly and twist and tug

lucky car - have a good day

Click to expand...

Grit Valve said:

Sounds like your be cooking then in your apron , and she will have the spanners out

Sounds good to me!

You just need too woo her now

What do you suggest cooking for her?

Click to expand...

Rachelkgr said:

Oh goodness! As I say, can't boil an egg! Rain stopped the calibration, today looks good.

Was trying to put the wood handle on the handbrake (yes I put grease on it). Now it's stuck. So do I try to remove it, or bang it on further with a rubber hammer. Only about an inch, from being on correctly.

Click to expand...

doz said:

Well no update. So what happened.

Is Rach still outside with the tape measure or is Rach indoors cookin me supper

Click to expand...

Rachelkgr said:

Ha ha! EAS nearly sorted. Went wrong at the end. I did not hit Stop in in the software! Doah! Need to do it all over again!

Could not get the handbrake wood grip on. Needs more sandpaper on the inside!

Did replace one of the 4 connectors behind the kick panels in the front.

So not all bad, could have gone better!

Click to expand...