series 3 sweet 16
Active Member
- Posts
- 774
I have my 69 series 2a facelift 88,
Now two things in question,
First is my crossmember, it's quite strong but the inner corners would need cut and replaced. What would you Recommend? How much would it even cost to replace and have fitted?
The other is the bulkhead corner driver side not too bad but I'd say 4 inch by 2 inch. Also the door pillars are rotted, how much would these cost or even how hard are they to even replace and what work would be involved, I am certified to weld mig but experience I admit is somewhat lacked.
I have brought new footwells too, as centre bulkhead is very strong corners are strong, how do you add pictures from an iPad mini?:doh:
Now two things in question,
First is my crossmember, it's quite strong but the inner corners would need cut and replaced. What would you Recommend? How much would it even cost to replace and have fitted?
The other is the bulkhead corner driver side not too bad but I'd say 4 inch by 2 inch. Also the door pillars are rotted, how much would these cost or even how hard are they to even replace and what work would be involved, I am certified to weld mig but experience I admit is somewhat lacked.
I have brought new footwells too, as centre bulkhead is very strong corners are strong, how do you add pictures from an iPad mini?:doh:
