Hi all i have a d2. Td5 just had auto rebuilt recently. I have a problem that randomly occurs in reverse on a slight incline it wont rev over 1000 rpm will do the same on flat ground if i put my foot on the brake. I have no issue in drive. has anyone had this issue
Td5 wont rev over 1000rpm in reverse
- Thread starter Hilto28
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 44,449
- Location
- East Dorset
Think this must be part of the problem.
I'd take it back to whoever did the rebuild and get them to do it again.
PopPops
Well-Known Member
- Posts
- 472
- Location
- Fareham, Hampshire
+1^^
But have you done a stall test? What year is the D2?
But have you done a stall test? What year is the D2?
Did that all was good.
Its a 2000 model
PopPops
Well-Known Member
- Posts
- 472
- Location
- Fareham, Hampshire
OK, it's probably a 10P engine then. Mine did something very similar when the MAF played up, but mine is a 16P (2004). I don't believe the MAF is used in the same way on the 10P.
sierrafery
Well-Known Member
- Posts
- 17,754
- Location
- Arad/Romania
Me too
I have changed the maf still dose it have had it on the scan tool cant see anything
- Posts
- 44,449
- Location
- East Dorset
Seriously, the MAF has feck all to do with this.
Disconnect it and it'll drive as it ought to anyway.
If any sensor is likely to cause the engine to not pick up, until your foot has been planted to the floor for a while, it'll be the MAP/IAT.
Ask me how I know!
But this would only be true if the motor did the same in first gear!
So I suspect the gearbox.
