Richarddiscoverytwo
Member
- Posts
- 97
I have searched all over the www and can't find where i can obtain an injector puller for a TD5...any ideas?
Thanks:scratching_chin:
Thanks:scratching_chin:
Td5 injector puller
- Thread starter Richarddiscoverytwo
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Buckhandle
Active Member
- Posts
- 247
- Location
- Denmark
Use a long Allen/Hex key .. worked for me.. twist it under the injector and lift ..
Richarddiscoverytwo
Member
- Posts
- 97
Thank you for the responses, most useful
Richard
Richard
ratty
I'm not special I'm limited edition
- Posts
- 34,277
I used a slide hammer on mine
eightinavee
Well-Known Member
- Posts
- 3,956
- Location
- UK.
I just use a heel bar,works well - it needs to,I seem to be ripping out TD5 injectors on a daily basis at the moment,did one as last job this evening.....
eddmco
Member
- Posts
- 58
- Location
- Bridge of Weir, Renfrewshire
I use a small pry bar, using the the handle end which is tapered and rounded at the tip.
Come in at a 45 degree angle from the right hand side with the tip just under the collar of the injector, rest the bar on the cylinder head at the nearest point, the gentlilest tap with a hammer will pop it out with ease.
Come in at a 45 degree angle from the right hand side with the tip just under the collar of the injector, rest the bar on the cylinder head at the nearest point, the gentlilest tap with a hammer will pop it out with ease.
