TD5 crank no start after overheating

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

TD52003

New Member
Posts
1
Hi, looking for some advice/help

My Disco td5 was running perfectly, but had got very hot. I stop and coolant was steaming from the engine. After topping up and leaving to cool. I set off again, however as soon as I pulled offf would rev above 2500/3000 rpm and felt like it was misfiring.

It drove for about another 5/10 mins, then died. Turned it back on and only ran for a few minutes with no power, then died again. Now it now won’t start at all and the fuel pump is making quite a funny noise.

I had codes the codes below come up, and have since replaced the injector wiring loom and tried a new ECU (which was programmed in) and still won’t fire.


There no sings of the head blown as coolant and oil still ok and level haven’t changed. There no exhaust gases coming out the top of the filler cap ( although a very small amount coming from the dip stick)

I’ve got fuel at the pressure regulator. Not sure on what pressure it’s at but is definitely a large flow and should be enough to run for a few seconds at least.

Not sure if there is a problem related to the overheating or just by coincidence something else has gone at the same time, as it’s weird how the problem progressively got worse it wasn’t just instant.


Any help is much appreciated.
IMG_1767.jpeg
IMG_1765.jpeg
IMG_1766.jpeg
 
Last edited:
Back
Top