Mantamad
New Member
- Posts
- 1,067
- Location
- Fife Scotland
What the feck is that all about - a total pain to fit back in place properly then get the screws to thread back up again. At least I can blame some headcase at BMW for such $hit design
TD4 Air Filter Housing
- Thread starter Mantamad
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Chaser
New Member
- Posts
- 2,175
you just need to know where your going wrong.......engage the slot on the left and keep it pulled in toward you as you lower the cover, keep it tilted backward so the back touches down first otherwise the 2 captive corner screws drop over the back edge of the base and your trying to screw them into nothing.
Mantamad
New Member
- Posts
- 1,067
- Location
- Fife Scotland
Thanks for the reply, I am not sure if the housing is buckled somewhere, all the holes line up but the back left part of the casing (when viewed from front looking into the engine) doesn't go down far enough to allow the screw to make contact with the thread - even tried it without the filter, watching it locate into the part at the back but still no luck.
Similar threads
