blocker2004
Member
- Posts
- 16
- Location
- Liverpool
Hi all, having problems removing lower bolt on starter motor on 2002 1.8 freelander 1. Is it removed from top or underneath or through wheel arch.
Starter motor removal
- Thread starter blocker2004
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
htr
Well-Known Member
- Posts
- 1,553
- Location
- Central Otago, Southern New Zealand
I think you can remove it from above, You will have to remove the air cleaner assembly...
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
On the td4 you have to take the battery holder of I do not know if it is the same I can not find my book but I am sure you can get to the bolts from the front
Last edited:
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
Great stuff. Thanks for reply. Is it a stud or nut and bolt at bottom.
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
Thanks for reply. Its the bottom nut and bolt or stud I can't get to.
GrumpyGel
Well-Known Member
- Posts
- 26,301
- Location
- Christchurch, New Zealand
Going by the last 4 posts it appears you're not necessarily to tech savy, so this might not be for you, but the following link shows you how to download the Rave Workshop Manual for Freelander...
https://www.landyzone.co.uk/land-rover/rave-disk-maintenance-manual.260227/
Make sure you download the later manual for the 1.8/TD4 cars.
I've never taken the starter off a 1.8, but the Rave manual will give step-by-step instructions.
https://www.landyzone.co.uk/land-rover/rave-disk-maintenance-manual.260227/
Make sure you download the later manual for the 1.8/TD4 cars.
I've never taken the starter off a 1.8, but the Rave manual will give step-by-step instructions.
pardec
Active Member
- Posts
- 993
- Location
- South Manchester- North Devon
1. Disconnect battery earth lead.
2. Remove air cleaner assembly.
3. Disconnect Lucar connector from starter motor.
4. Remove nut and disconnect battery lead from
starter solenoid.
5. Remove lower nut and bolt securing starter
motor.
6. Remove bolt securing steady bar to engine LH
mounting.
7. Remove upper nut and bolt securing starter
motor.
8. Remove engine steady bar.
9. Remove starter motor.
2. Remove air cleaner assembly.
3. Disconnect Lucar connector from starter motor.
4. Remove nut and disconnect battery lead from
starter solenoid.
5. Remove lower nut and bolt securing starter
motor.
6. Remove bolt securing steady bar to engine LH
mounting.
7. Remove upper nut and bolt securing starter
motor.
8. Remove engine steady bar.
9. Remove starter motor.
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
Thanks for reply but I only wanted to find out if it was a bolt or stud. It was stripped down and getting dark. Job done now.
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
blocker2004
Member
- Posts
- 16
- Location
- Liverpool
Thank you for your reply. Sorted.
