special seat adaptors
- Thread starter hadenps
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Grippa
New Member
- Posts
- 12,310
- Location
- Where the winches aren't.
Unlikely that you can get any kind of adapter off the shelf. It isn't difficult to fit different seats into most motors though. I had rangie seats in my 90. Just had to cut a couple of lengths of 6mm bar for each, drill appropriate holes for the bolts that don't line up & fit spacers below if needed.
Do any of the holes line up? Are the seat rails the same distance apart? If so it should be fairly easy.
Do any of the holes line up? Are the seat rails the same distance apart? If so it should be fairly easy.
Grippa
New Member
- Posts
- 12,310
- Location
- Where the winches aren't.
Is that the distance from one of the sliding rails to the other? difficult to tell you exactly how to do it without seeing the seat and the vehicle you're fitting it too. I dunt knowmuch about Disco's so couldn't tell you much more.
You should be able to fit most seats to most vehicles with a couple of lengths of 6mm steel bar (about 20/25mm wide), a few bolts & a bit of imagination.
Try posting again in the Disco section to see if anyone has fitted similar seats in a Disco 1 already.
You should be able to fit most seats to most vehicles with a couple of lengths of 6mm steel bar (about 20/25mm wide), a few bolts & a bit of imagination.
Try posting again in the Disco section to see if anyone has fitted similar seats in a Disco 1 already.
