RKServicing
Active Member
- Posts
- 757
- Location
- bicester
As the mot is due this week thought I should replace my unwelded sills as I squashed them doing the body lift.
Got a rear door trim aswell while I'm atit
Think I need more lift aswell!
Some new toys! Better get the welder out
- Thread starter RKServicing
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
As the mot is due this week thought I should replace my unwelded sills as I squashed them doing the body lift.
Got a rear door trim aswell while I'm atit
Think I need more lift aswell!
DiscoPol
Well-Known Member
- Posts
- 6,376
- Location
- The Land of Po
Ha HA you have lift envy!
RKServicing
Active Member
- Posts
- 757
- Location
- bicester
Not envy, an obsession haha Mines the blue one.
DiscoPol
Well-Known Member
- Posts
- 6,376
- Location
- The Land of Po
andrewblueboy
Active Member
- Posts
- 245
- Location
- bolton
im in middle of doing the same thing replacing my cills with box section.found it lot easier changing the body mounts at same time. so far one cill is done only to run out of wire to finsh floor off.at momment it plastered in red oxide.
RKServicing
Active Member
- Posts
- 757
- Location
- bicester
damn you, now i have lift envy
Haha sorry mate!
Andrew I'm doing the body mounts aswell. But going to make my own rather than spend 35 quid for a pair!! :O
andrewblueboy
Active Member
- Posts
- 245
- Location
- bolton
robbh
Crazier than a box of frogs on acid
- Posts
- 1,755
- Location
- Edge of the New Forest. Wiltshire
RKServicing
Active Member
- Posts
- 757
- Location
- bicester
That's what I plan on doing. Although will weld on underneath. As the rear mounts have collapsed I need to sort that once I've welded the sills in(to jack body up) then I can fit the 4 middle mounts.
