Should I Skim?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
RodneyA

RodneyA

Active Member
Posts
295
Location
Ayrshire, South West Scotland
I'm going to change the head gasket on my 2.5na next week when the parts arrive, there's been no serious issues just a little bit of smoke and pressure out the oil filler cap so I'm going to get it change before it gets worse.

If the heads fine IE not badly Warped is it worth giving it a small skim as a preventative measure, there's a local place that can so it for £35

Thanks
Chris
 
RodneyA said:
I'm going to change the head gasket on my 2.5na next week when the parts arrive, there's been no serious issues just a little bit of smoke and pressure out the oil filler cap so I'm going to get it change before it gets worse.

If the heads fine IE not badly Warped is it worth giving it a small skim as a preventative measure, there's a local place that can so it for £35

Thanks
Chris
Click to expand...

If you got them symptoms might want to look at the rings and lap the valves. why you think head gasket?
 
It's not that I think it's the head gasket it's more of I'm just going to replace it while it's all off. I'll have a google and see what the rings and lap the valves are. This is all new to me :)
 
the problem with skimming cats iron 2.5 heads is hot spots they should protrude but only by 2-3 thou ,if head face is unmarked where fire ring contacts i wouldnt bother except check carefully between valve for fine cracks
 
The head was actually ok just a little bit of gasket failure leading to a tad of warping which is away getting a bit of skimming but what about the engine block end, there is a little but of rust in it, is this normal?

2 of the push Rods where also bent. No sign of any other damage

baru4uze.jpg
 
not difficult ,though you may need to know what size and if others are ok usually its more than one though with one been more obvious
 
I've had a look and it's only about £25 for a set of 4 so I may as well change all 4 while I'm at it, is there anything else I need to order and or look at while I'm there?

Also with the little bit of rust on the waterways, should I be worried about them?
 
RodneyA said:
I've had a look and it's only about £25 for a set of 4 so I may as well change all 4 while I'm at it, is there anything else I need to order and or look at while I'm there?

Also with the little bit of rust on the waterways, should I be worried about them?
Click to expand...

are you sure £25 each would be more likely and are they std +20 ,+40 etc
 
Also with the little bit of rust on the waterways, should I be worried about them?[/QUOTE]

no its very good as far as block face goes it looks like its been skimmed in not too distant past ,theres a brass block drain on exhaust side of block you should undo it before removing head ,blow bolt holes out wel before fitting head back ,youd need new big end shells too
 
You must log in or register to reply here.

Similar threads

V
LR4 Technical advice please.
Replies
4
Views
898
Graculus
Graculus
C
repairing bulkhead in situ
Replies
2
Views
303
ER1C
ER1C
P
What's this noise?
Replies
2
Views
446
Jim6503
J
Rich W
Disco 2 TD5 camshaft rotation torque
Replies
5
Views
625
Rich W
Rich W
Hammer'n'tongs
Tyres wearing unevenly:- Axle ends out of alignment
Replies
9
Views
1K
Hammer'n'tongs
Hammer'n'tongs
Back
Top