Shot blasted bulkhead

I had this done. it came up very nicely. I got it off ebay back in July but took ages to get round to getting it blasted.

There is actually less rot than I thought there would be.

The passenger side footwell is quite badly pitted so I think I will replace that one. The driver's side is not bad at all apart from some holes at one side.

The only other problems are some small holes on the vertical area below each hinge. These shouldn't be too difficult to fix.

Something I forgot to ask is:

What is the product called that is used to seal the seams, and where can I get it?

Seam sealer. Available as an adhesive or rubber based. I use tiger seal. A little pricey but very good.

Seconded. BTW, that bulkhead has actually turned out quite nice.