Shock absorber bushes

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
W

Webley1991

Well-Known Member
Posts
2,579
Location
London
I ordered a pair of new rear shock absorbers for my Series 3.

The four conical rubber bushes were included with each one. However, am I correct that there should be a steel tube that goes through the middle of these bushes? These tubes were not in the box if they should be there.

What should the length of this tube be? I may be able to make four of them.

Thanks for any info.
 
Thanks for that. The photo on the box for the shocks shows tubes in place so this confused me.

However, the split pins that they sent are going to be far too big for the holes on the stubs.
 
the pic on the box they came in probably isnt the type you ordered probably just 1 pic on evry box of shocks no matter what make or style
 
The steel tube is the bit on the axle and chassis that the bushes and washer go over. It's quite a chunky split pin.
 
tottot said:
If they are not a good fit then stubs are worn.
Click to expand...

I took the shock on one side off today. "Worn" is an understatement for the stubs. The surface of them has completely rusted away. I may just have to clean them up and put them back loose. I can't justify the expense of getting new ones welded on.
 
Webley1991 said:
I took the shock on one side off today. "Worn" is an understatement for the stubs. The surface of them has completely rusted away. I may just have to clean them up and put them back loose. I can't justify the expense of getting new ones welded on.
Click to expand...
MOT fail and bushes will wear away in 10 minutes.Is there no-one on here that will weld new stubs on for you. I would do it but I am 370miles away.
 
I work at a place that has welding kit. It would mean putting everything back together to get my series 3 there then having to take it apart again. Also, they don't like anyone doing home work in work time, and it is pretty obvious having a Land Rover in the workshop. The stubs on the bottom plates are also pretty bad but I suppose the plates could just be replaced. How much would they cost?
 
Webley1991 said:
I work at a place that has welding kit. It would mean putting everything back together to get my series 3 there then having to take it apart again. Also, they don't like anyone doing home work in work time, and it is pretty obvious having a Land Rover in the workshop. The stubs on the bottom plates are also pretty bad but I suppose the plates could just be replaced. How much would they cost?
Click to expand...
There are 3 on Ebay just now for not a lot of money. I will get the item number.Dont know how to do the linky thing.
 
The holes in the front (of rear) spring hangers have also worn to be oval. Does that mean the hangers need to be replaced as well?
 
Last edited:
I got a new-ish set of springs off ebay to replace the old ones as they are corroded beyond recovery. The bushes in there are alright.

As long as I can get it through the next MOT then it's fine. I could sink more money into it than it's actually worth if I did everything.
 
You must log in or register to reply here.

Similar threads

mad85
Disco 2 Disco 2 shock bushes options?
Replies
13
Views
361
sierrafery
sierrafery
A
130 Shock Absorber Size
Replies
2
Views
167
Aydencj
A
J
Cracking new shock absorber bushes
Replies
8
Views
876
dag019
dag019
C
Windscreen hinge pivot bolts
Replies
7
Views
695
WoodyO
WoodyO
B
Which shocks?
Replies
14
Views
693
BigJessie
B
Back
Top