Rustproofing - Bad Job?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Z

ZeHerman

Member
Posts
32
Location
Germany
Good evening everyone,

I need some help to objectively judge a rather pricey rustproofing job done on my Defender 300 TDI. The garage used FluidFilm products for the inside of doors/chassis and the black fluid film stuff for the underbody. I had this done just last week, and I am not very happy with it. While there are some obvious problems, I'd appreciate your opinion on the following points:

1. The tank, axles, differential were not covered at all. I believe they should have been. Am I right?

2. The inside of the chassis is only partially covered in some areas. Surely this is not correct? See here:

3. The rear door is rather artistically covered in FluidFilm under the cover. See Image below.

I'd love to get some second opinions on this and appreciate your support.

20211004-132558.jpg
 
1. Yes
2. Yes
3. ****e..

Chassis pics look like you are just spraying on a rusted chassis, not the worst thing you can do but will only prolong rather than rectify.
 
I think your next move should be one of them cheap usb boroscopes and have a look in the chassis.
Looking at the spray pattern in the rear door, that is what it is going to be like in the chassis, is shti with next to no coverage.
 
Thank you for your replies. A small USB boroscope might not be a bad idea. I contacted the garage again for comment/a solution. Let's hope there is a solution to this.
 
l wouldn't worry too much about the axles and differential not being treated, although spraying black wax on them makes them look nice, they don't generally rot (unless someone proves me incorrect) so it's not necessary.

But the back door application is just crap, almost as if the operator was blind, and just sprayed around the general area where they thought the door was.
 
lightning said:
l wouldn't worry too much about the axles and differential not being treated, although spraying black wax on them makes them look nice, they don't generally rot (unless someone proves me incorrect) so it's not necessary.

But the back door application is just crap, almost as if the operator was blind, and just sprayed around the general area where they thought the door was.
Click to expand...

Usually from the inside out due to condensation ....
 
This reminds me of a film, where 2 chaps were paid to paint a barn or something and it was really high. One of the chaps came up with the idea rather than actually paint it they would just chuck a tennis ball in the paint and throw it up there, they did that a few hundred times and from below it looked like it was painted over the bits that were needed.
 
The main thing that rustproofing job will do, is cause the Landy to set on fire when you take it in for corrosion repair and they start welding the chassis.
 
Last edited:
You must log in or register to reply here.

Similar threads

G
Defender 90 advice
2
Replies
30
Views
2K
grandy21
G
L
Got my eyes on this 110 XS for sale but concern with rust
Replies
17
Views
1K
lynall
L
johnnymarrsbarres
Defender 90 tdci alarm question
Replies
5
Views
334
Wimblowdriver
Wimblowdriver
dag019
Seat belt bolt/fitting kit
Replies
1
Views
163
julianf
julianf
L
Landy 110 1992 (J368 XSG) - is it as bad as mechanic says..
2 3
Replies
44
Views
4K
tottot
tottot
Back
Top