Roof light bars - where to put the wires through?

mundungus · Sep 17, 2011

How do people get the wires to the inside typically? Do you drill through the body work somewhere, if so where?

Any pics?

storm99 · Sep 17, 2011

Guttering channel, with a rubber grommet, then down the inside to the dash.

matthew2riches · Sep 17, 2011

I look mine down the side of the snorkel and under the bonnet, through bulkhead and into fusebox.

mundungus · Sep 17, 2011

storm99 said:
Guttering channel, with a rubber grommet, then down the inside to the dash.

What do you mean exactly, drill through the roof just above the gutter? Wouldn't that allow all the water in the gutter to go straight into the headlining?

mundungus · Sep 17, 2011

matthew2riches said:
I look mine down the side of the snorkel and under the bonnet, through bulkhead and into fusebox.

I thought about that, but really wanted to hide the wires if possible. The snorkel seems just a bit far away from the roof that it would be obvious if i put wires across to it.

storm99 · Sep 17, 2011

mundungus said:
What do you mean exactly, drill through the roof just above the gutter? Wouldn't that allow all the water in the gutter to go straight into the headlining?

Hence the grommet. Works fine. Drill IN the gutter, its about 1cm out from the door edge but allows you to run the wiring into the cab without it being visible.

mick the builder · Sep 17, 2011

Mine runs down the snorkel and in under the corner of the bonnet. No drilling and looks good

Roof light bars - where to put the wires through?

mundungus

Active Member

storm99

Spreading Joy & Harmony

matthew2riches

New Member

mundungus

Active Member

mundungus

Active Member

storm99

Spreading Joy & Harmony

mick the builder

Well-Known Member

Similar threads