Removing Key Fob PCB

GrumpyGel · Aug 3, 2015

The rubber buttons on our key fob are worn out/broken and its getting difficult to press the buttons. I can get hold of some Rover car fobs that appear identical - so I'm hoping to swap over the rubber bits.
I've opened our fob up, but I cant see how to remove the PCB to get to the rubber bits behind it - any ideas?
Its the early fob for a 99 L Series.

DastardlyDan · Aug 3, 2015

On mine, it's always been a case of gently pull, and they fall out

GrumpyGel · Aug 3, 2015

Thanks DD - all I did today was open it up and 2 of the3 solders on the battery clip had bust, PCB looks fragile and quite tight in - I'll give it a bit more effort, see what happens !

htr · Aug 3, 2015

You can get a replacement shell very cheaply from Rimmers - £4.80 ex p't number
YWX101010

htr · Aug 3, 2015

See there is another NZ member, in Chch too - MikeinNZ

GrumpyGel · Aug 3, 2015

htr said:
You can get a replacement shell very cheaply from Rimmers - £4.80 ex p't number
YWX101010

For once, I can get a bit cheaper in NZ! All-be-it 2nd hand http://www.trademe.co.nz/Browse/Listing.aspx?id=924868357

htr said:
See there is another NZ member, in Chch too - MikeinNZ

Yeh, he's written on the new International thread https://www.landyzone.co.uk/forum/new-zealand.114/

Removing Key Fob PCB

GrumpyGel

Well-Known Member

DastardlyDan

Active Member

GrumpyGel

Well-Known Member

htr

Well-Known Member

htr

Well-Known Member

GrumpyGel

Well-Known Member

Similar threads