L322 Remove cylinder head with exhaust manifold?

L322Driver · Feb 1, 2019

Hi
I have a L322 with the BMW M62 engine. I am going to remove the cylinder heads. The book of words says the exhaust manifolds should be removed first but this looks like a very hard job! There looks to be enough room to remove the heads with the manifolds, has anyone any experience of this?
Thanks in anticipation....

biketeacherdave · Feb 1, 2019

Remove them 1st

L322Driver · Feb 11, 2019

biketeacherdave said:
Remove them 1st

Interesting, do you speak from bitter experience?
The four nuts holding the down pipes to the manifolds have rusted away such that no socket or grips can get hold. The only solution will be to cut the studs. Does anyone know if the studs in the manifold are replaceable?

Saint.V8 · Feb 11, 2019

L322Driver said:
Interesting, do you speak from bitter experience?
The four nuts holding the down pipes to the manifolds have rusted away such that no socket or grips can get hold. The only solution will be to cut the studs. Does anyone know if the studs in the manifold are replaceable?

He does speak from experince......well honed amd learned experience.

Removed, stripped and rebuilt a replacement engine for a friend of his.....on the driveway.....in all weather.....

The experience wasnt too bitter, he and his mate did a bang up job....

brianp38dse · Feb 11, 2019

Have you tried the Irwin nut removers they are very good and a must for old green oval motors
https://www.ebay.co.uk/itm/Irwin-Bo...h=item51f9ba8017:g:SnUAAOSwH~1ajaXF:rk:1:pf:0

Henry_b · Feb 11, 2019

Remove the manifolds first.

Or the entire engine, like I did.

If you want a challenge try doing that

kg74 · Feb 11, 2019

Leave them on - remove the two bolts that attach to the exhaust flange after the header. Have a helper as the extra weight will be felt. Install them the same way, but be alert of the coolant hoses on Bank 2 as they can get in the way. Have a helper guide the bolts into the exhaust flange or you will have to cut the exhaust to get it to fit.

Been there done that using both systems. Leaving them on is way easier and you can torque everything correctly.

Henry_b · Feb 11, 2019

It's a pain in the arse/near impossible to remove and refit the heads with the mani's attached.

Plus removing the bolts and levering the manifolds away isn't that difficult makes things much easier if you work on your own..

L322 Remove cylinder head with exhaust manifold?

L322Driver

New Member

biketeacherdave

Well-Known Member

L322Driver

New Member

Saint.V8

Dyed-in-the-wool 100% RR Junkie

brianp38dse

Well-Known Member

Henry_b

Think outside, no box required.

kg74

Member

Henry_b

Think outside, no box required.

Similar threads