Rebuilding Wolf door tops?
- Thread starter nobber
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
yes
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
screws can be hard to undo after first finding them by dragging a screw driver along the center of channel till you feel a steel screw head, its best getting new screws too , its not felt its thin steel channel covered in felt, some ive had as a ready to fit kit others, lengths of channel you cut to length and drilled the holes for the screws and made lock slot ,but its not too difficult at all
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
i cant help you then the ones we did had felted channel
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
yes in that series has a vertical and mil or early defender sloped glass
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
I did my sloped glass sliding windows myself, wasn’t actually hard just took a bit of time to get it all apart.
The bit the windows slides in has 3 small screws down into the frame iirc, then you undo the screws (or drill out the rivets) on the rest of the frame and the it all comes apart. Bit fiddly but okay
The bit the windows slides in has 3 small screws down into the frame iirc, then you undo the screws (or drill out the rivets) on the rest of the frame and the it all comes apart. Bit fiddly but okay
Did you just use the felt? MTC7622
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Yes, replaced all of it with some extruded rubber covered with felt
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Yep, I forget where I got them from
But it was a while ago.
A company sells kits aswell iirc
callisr
Well-Known Member
- Posts
- 615
- Location
- Burton-on-Trent, Staffs
Found this thread while researching the same job for my 90.
Garrison Outfitters sell a kit (available from Mud UK). It costs about £100 for both doors but is supposed to be better than the original stuff.
Done yours yet Nobber? If so, what did you use in the end?
Rich
Garrison Outfitters sell a kit (available from Mud UK). It costs about £100 for both doors but is supposed to be better than the original stuff.
Done yours yet Nobber? If so, what did you use in the end?
Rich
Huddy84
Well-Known Member
- Posts
- 746
- Location
- East Anglia
fsmr
Member
- Posts
- 17
- Location
- Oakham Rutland
was going to say Woolies at the Deepings would have the felt
I have just put the alloy rocky mountain tops on my S3, not cheap but brilliant in winter, same split sliding glass in rubber channel and stainless mount studding so no corrosion
I have just put the alloy rocky mountain tops on my S3, not cheap but brilliant in winter, same split sliding glass in rubber channel and stainless mount studding so no corrosion
flat
Well-Known Member
- Posts
- 9,075
- Location
- Far away from you!!
Stainless mounts is an excellent uograde. - member here made some a while back, I have swapped mine over and they make getting the tops of much easier
