Sambne
New Member
- Posts
- 1
- Location
- Brisbane, Australia
Hello from Brisbane, Australia!
I am currently rebuilding my 300tdi - had a hone done professionally and everything is within factory specs.
Have gapped the piston rings, measured the pistons, the bores etc etc... all measure within (standard) spec.
On fitting the pistons into their cylinders, they have a slight bit of movement within the cylinder (a wiggle, if you will). I'm wondering if this is normal? I realise that the alum pistons expand at temperature, but want to make sure before I continue with the build.
Everything has been measured and is acceptable, but just want to be sure on the movement.
Thanks in advance,
Sam
I am currently rebuilding my 300tdi - had a hone done professionally and everything is within factory specs.
Have gapped the piston rings, measured the pistons, the bores etc etc... all measure within (standard) spec.
On fitting the pistons into their cylinders, they have a slight bit of movement within the cylinder (a wiggle, if you will). I'm wondering if this is normal? I realise that the alum pistons expand at temperature, but want to make sure before I continue with the build.
Everything has been measured and is acceptable, but just want to be sure on the movement.
Thanks in advance,
Sam
