Rear Wiring Loom to Engine Bay

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

philsefo

Active Member
Posts
287
Location
Manchester/ wirral
Hello,

So this weekend i finally managed to get my rear wiring loom through the chassis rail and back to the engine bay.

Managed to plug 80% of the plugs back in straight away but have two left.

One - White with purple line
Two - Green with brown line

Any ideas?

Does anyone have a diagram of the rear wiring loom?


Also does anyone have an ideas or bought anything to tidy up the electrics in the engine bay.

My 90 is a 1986 and has a engine conversion so wires everywhere, loads of cable ties and it looks crap.

Thanks
 
I can't find a White/Purple, but a Purple/White is generally for the internal lights.
Green/Brown should be from the reversing light switch to the reversing lamp
 
Last edited:
why did you run it through the chassis? It's much better off outside the chassis, I've got the wiring diagram for your Mandy, ill have a butchers tonight, was it always a diesel?
 
why did you run it through the chassis? It's much better off outside the chassis, I've got the wiring diagram for your Mandy, ill have a butchers tonight, was it always a diesel?

I just replaced it to where it was, to be fair it was a pain to do. Next time i'll run it down the outside

It was a diesel (NA i think) and now a v8.

It has a trailer socket, well did. So some of the wires might go to running that.
 
I'll pull the diagram out tonight but a quick look at the Lucas colour chart says its for a fuel pump, which isn't right, is your fuel sender all wired in?
 
Back
Top