Rear windows not shutting 100%

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

bonnybrook

Active Member
Posts
424
Just washed the car and noticed the rear windows is not shutting 100% - should there be a small gap or should it close flush with the car? If you open the door it does the usual drop half and inch and then up when you close it. It's closing beyond the seal but not flush with the door frame.

This follows on from Friday when the rear door wouldn't open - operated the window from inside then it was ok and still is. First time I have ever had this problem.
 
I'm not sure if you can calibrate the window without disconnecting the battery and then follow the instructions in the owners manual.

Taildoor glass
If the battery has been disconnected, the
taildoor glass will need to be recalibrated. If the
alarm was armed when the battery was
disconnected (or discharged), disarm the alarm
after battery reconnection - the taildoor glass
will fully lower. This will happen automatically if
the alarm was in a disarmed state when the
battery was disconnected.
After battery reconnection, fully raise the
taildoor glass (if the glass is not fully raised, an
error ‘beep’ will sound) - the taildoor glass is
now recalibrated.
 
If the battery has been disconnected, the taildoor glass will need to be recalibrated. If the alarm was armed when the battery was disconnected (or discharged), disarm the alarm after reconnection - the glass will fully lower.

After battery reconnection, fully raise the glass (if the glass is not fully raised, an 'error' beep will sound) - the taildoor glass is now calibrated.

Page 30 owners handbook :)

i.e disconnect and reconnect the battery first
 
Back
Top