Radio Code Input ?

Peeps,
Anyone have a Landrover single slot cd/radio, i have the code but do not know which button to press to accept
Anyone here know or have a manual :doh:

frenchy62 said:

Peeps,
Anyone have a Landrover single slot cd/radio, i have the code but do not know which button to press to accept
Anyone here know or have a manual :doh:

Click to expand...

Security Code
ENTERING THE SECURITY CODE
R660 audio system
C-42 audio system
R990 audio system
If the code has not already been entered, or
power to the set has been interrupted, the code
MUST be entered before the set will operate.
Enter the code as follows:
Switch on the radio (‘CODE’ appears in the
display). Press pre-set button 1.
Press either the up or down
tuning button (highlighted in
illustration) until the first digit of
the security code appears in the display. Press
pre-set 1 to store the first digit in the unit's
memory.
Use either tuning button to select
the second digit of the code (until
the correct digit appears in the
display). Press pre-set 1 to store the second
digit.
Select the third digit, again using
the tuning buttons (until the
correct digit is displayed). Press
pre-set 1 to store the third digit.
Select the final digit (the display
now shows the full four digit
code). Press pre-set 1 to store the
final digit.
If the correct code has been selected, a two-tone
bleep will sound and the radio will operate.
If an incorrect code has been entered, the first
time delay period commences. During the delay
period, ‘Err’, ‘CODE WAIT’ or ‘WAIT’ appears in
the display - DO NOT switch off. At the end of the
delay period, ‘CODE’ reappears in the display and
you can then enter the correct code. Remember;
the time delay period doubles each time an
incorrect code is entered.
NOTE: On R660 models, a warning bleep sounds
at the beginning of the first time delay period.
FM1 FM1 LOUD LOUD
LD MAN
POWER BAS BAS TRE TRE
BAL BAL FAD FAD 1 2 3 4
ICE0064B
1
ICE0220
ICE0085