Pedal Box Sound Proofing Sagging

NinkyNonk · Feb 22, 2017

When I first got my Defender a couple of years back the bit of sound proofing on the bulkhead around the pedals required wedging back into place about once a month. Over time it has gradually got more and more frequent, and at the moment it drops to this position pretty much every journey.

Luckily it makes no odds to my feet operating the pedals, I only notice when I next get in that it has dropped again. Anyone have any clever ideas of how I could fix it into position without sticking it to the bulkhead?

james6546 · Feb 23, 2017

I just used some impact adhesive, has stayed on there since. As far as I can tell it was glued out of the factory

NinkyNonk · Feb 23, 2017

james6546 said:
I just used some impact adhesive, has stayed on there since. As far as I can tell it was glued out of the factory

Ah, ok. Will get hold of some and give it a go! Cheers muchly

james6546 · Feb 23, 2017

NinkyNonk said:
Ah, ok. Will get hold of some and give it a go! Cheers muchly

If you can use "high temperature contact adhesive" as evostick tends to peel off on a really hot day

bankz5152 · Feb 23, 2017

I used some self tappers, never know when youre going to need to get under there!

neilly · Feb 23, 2017

+1 Self tappers and penny washers.

Cheers

zeaphod · Feb 23, 2017

Looks a bit dodgy, you wouldn't want it to get fouled up around the pedals. I'd take it off until sorted.

Retroanaconda · Feb 23, 2017

There's a strip to retain it that picks up the lower screws for the dash housing, however there's still an element of sagging.

Self tappers and penny washers as above, just mind where you're drilling as there could be various pipes/wires etc. on the other side!

NinkyNonk · Feb 23, 2017

Thanks for all the advice people, looks like I'll be getting the drill out. The edge is pretty shot and tattered. Will come up with something though

zeaphod said:
Looks a bit dodgy, you wouldn't want it to get fouled up around the pedals. I'd take it off until sorted.

It would really have to go some to snag the pedals, when your feet are there it holds it up out of the way.

mikevenables · Mar 31, 2017

Way after you asked but with the same problem I used some heavy duty velcro strips designed to hang tools. works just fine…

apeers · Mar 31, 2017

does anyone know where to get replacements from mine have long since perished and I either need to get new replacements or find some patterns to make some new ones

Hairball · Mar 31, 2017

Ripped mine out when I put a peddle lock box on
To be honest didn't really make that much difference sound wise and my boots kept catching it any way

Pedal Box Sound Proofing Sagging

NinkyNonk

Active Member

james6546

Well-Known Member

NinkyNonk

Active Member

james6546

Well-Known Member

bankz5152

Well-Known Member

neilly

Well-Known Member

zeaphod

Well-Known Member

Retroanaconda

Well-Known Member

NinkyNonk

Active Member

mikevenables

Member

apeers

Member

Hairball

Active Member

Similar threads