p38 Eas Fault

Big vee · Nov 5, 2012

Hi all My p38 40.se manual i have just got out the garage to do a few jobs. i brought the software and lead but can not get the 2 to connect just red box no green idle. i have cleaned the plug and new plug but no joy . untill i clear the faults were do i go . apart from a box of matches

rodntod · Nov 5, 2012

Big vee said:
Hi all My p38 40.se manual i have just got out the garage to do a few jobs. i brought the software and lead but can not get the 2 to connect just red box no green idle. i have cleaned the plug and new plug but no joy . untill i clear the faults were do i go . apart from a box of matches

There is a fuse linked to diagnostic conn,might be 35 in the underbonnet fuse box.check its not blown

Big vee · Nov 5, 2012

hi have checked fuse it looks ok a 5 amp is in there. at a lost only thing i can think of is lead no good

mozz smith · Nov 5, 2012

hi , P.M. datatek he is the master on eas .cheers mozz :clap2:

rodntod · Nov 5, 2012

mozz smith said:
hi , P.M. datatek he is the master on eas .cheers mozz :clap2:

As Mozz says Datatek is thee man for Eas and supplies the cables as well as software.

Datatek · Nov 5, 2012

If you are using a USB to serial adaptor, it's quite likely to be a problem with the drivers especially if you run Vista or 7.

Big vee · Nov 5, 2012

Have sent a pm thanks

forthbridge · Nov 5, 2012

Did you sort the Com Port number from your computer ? Mine won't work unless the right one is activated. I think its in device manager somewhere but the instructions should say.

Big vee · Nov 5, 2012

thanks all hopefully sorted will try again tomorrow as to dark

p38 Eas Fault

Big vee

Active Member

rodntod

Active Member

Big vee

Active Member

mozz smith

Well-Known Member

rodntod

Active Member

Datatek

Well-Known Member

Big vee

Active Member

forthbridge

Active Member

Big vee

Active Member

Similar threads