Original colour identification
- Thread starter mudmut
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
bluedog333
Well-Known Member
- Posts
- 5,436
- Location
- Henley on Thames, Oxfordshire
What year is it?
It’s a 1989
bluedog333
Well-Known Member
- Posts
- 5,436
- Location
- Henley on Thames, Oxfordshire
It will either be LRC392 Shire Blue, or LRC424 Arles Blue. It’s difficult to tell from a photo which it actually is! If you know when yours was built (from the VIN) then that may aid you, as Arles was after August ‘89
It was registered August 89
wireman
Well-Known Member
- Posts
- 1,169
- Location
- Warrington
I think it .might be Shire Blue too.
doriz
Well-Known Member
- Posts
- 17,312
Wind jammer blue
AB4
Member
- Posts
- 16
Hi,
Mine is Arles Blue 1990 if that's any help. I wasn't sure and I emailed Landrover. They were very swift with their reply.
Mine is Arles Blue 1990 if that's any help. I wasn't sure and I emailed Landrover. They were very swift with their reply.
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Have you used coach enamel?
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Yes, it's brilliant to use and Paintman's paints are great, very high quality and the company's great to deal with. Have used both roller and aerosols with both giving excellent finish - the aerosols are good but they have a tendency to over fan out. Do use Paintman primers as many others react with synthetic enamels + UPOL #8 acid etch gives excellent results. If you don't have a mask set up recommend using Gerson 2k masks, they're the best disposables available.
That`s good to know, I will be spraying as have a decent compressor and gun, but never used it, dose it flat and polish ok if it picks up any laning rash?
v8250
Well-Known Member
- Posts
- 6,872
- Location
- Deepest Darkest...
Yes, flats and polishes perfectly but like all paints don't flat & polish until really dry/hard[!]
I've also found spray first coat, let flash off for ~20 mins, then spray second coat :. wet on wet, and there's very little orange peel. I've just aerosol sprayed my new doors like this and there's no need to flatten back. One could even lay three coats if wanted.
I've also found spray first coat, let flash off for ~20 mins, then spray second coat :. wet on wet, and there's very little orange peel. I've just aerosol sprayed my new doors like this and there's no need to flatten back. One could even lay three coats if wanted.
That sounds great, just need to definitely decide on the color now
