Hi all. Put my nanocom evo on and done a cylinder check at tickover. All cylinders read about 1 or 2 except cylinder 5 which seems to read -9. Anyone got any ideas. Motor starts and runs fine although a bit chuggy on takeoff. iiam still losing a little water and fear head gasket or water pump but just wondered if this could be an indicayer.
nanocom cylinder readings
- Thread starter landmark
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shifty1962
Well-Known Member
- Posts
- 4,209
- Location
- The Winchester Club - Englandshire
Was engine properly warmed up?
sierrafery
Well-Known Member
- Posts
- 17,872
- Location
- Arad/Romania
always cyl 5 wears out first due to the absence of glowplug on it ... so did mine too
Last edited:
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
and been at rear of engine ?
Buckhandle
Active Member
- Posts
- 247
- Location
- Denmark
Once I read, as long as the unbalance is below double digits (+/- 10) - then no problem ..
Comments anyone?
Lars
Comments anyone?
Lars
Shifty1962
Well-Known Member
- Posts
- 4,209
- Location
- The Winchester Club - Englandshire
Mine jigger about +-2 on each pot but No5 is always a bit more twitchy until the engine warms up.
sierrafery
Well-Known Member
- Posts
- 17,872
- Location
- Arad/Romania
that's a bit exagerated, see the second page 10'th line of this document http://web.nanocom.it/download/DIAGNOSTIC FUNCTION OF THE TD5 ENGINE.pdf
Buckhandle
Active Member
- Posts
- 247
- Location
- Denmark
Thx for clarifying!
